STP16DP05XTTR STMicroelectronics, STP16DP05XTTR Datasheet - Page 17

• Manufacturer Part Number: STP16DP05XTTR
• Description: IC LED DRIVER LINEAR 24-TSSOP
• Manufacturer: STMicroelectronics
• Type: Linear (Serial Interface)r

Specifications of STP16DP05XTTR

• Constant Current: Yes
• Topology: 16-Bit Shift Register
• Number Of Outputs: 16
• Internal Driver: Yes
• Type - Primary: General Purpose
• Frequency: 30MHz
• Voltage - Supply: 3 V ~ 5.5 V
• Voltage - Output: 20V
• Mounting Type: Surface Mount
• Package / Case: 24-TSSOP Exposed Pad, 24-eTSSOP, 24-HTSSOP
• Operating Temperature: -40°C ~ 125°C
• Current - Output / Channel: 100mA
• Internal Switch(s): Yes
• Low Level Output Current: - 1 mA
• High Level Output Current: + 1 mA
• Operating Supply Voltage: 3 V to 5.5 V
• Maximum Supply Current: 14.5 mA
• Maximum Operating Temperature: + 125 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Led Driver Application: LED Displays
• No. Of Outputs: 16
• Output Current: 100mA
• Output Voltage: 20V
• Input Voltage: 3V To 5.5V
• Operating Temperature (min): -40C
• Operating Temperature Classification: Automotive
• Operating Temperature (max): 125C
• Package Type: TSSOP EP
• Rad Hardened: No
• For Use With: 497-9091 - LED BOARD FOR STM32 STP16DP05497-9087 - LED MATRIX DISPLAY PANEL
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Efficiency: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 497-5977-2

STP16DP05
7.2
Phase two: “error detection”
The 16 data bits must be set “1” in order to set ON all the outputs during the detection. The
data are latched by LE/DM1 and after that the outputs are ready for the detection process.
When the micro controller switches the OE\DM2 to LOW, the device drives the LEDs in
order to analyze if an OPEN or SHORT condition has occurred.
Figure 16. Detection diagram
The LEDs status will be detected at least in 1 microsecond and after this time the
microcontroller sets OE\DM2 in HIGH state and the output data detection result will go to
the microprocessor via SDO.
Detection mode and normal mode use both the same format data. As soon as all the
detection data bits are available on the serial line, the device may go back to normal mode
of operation. To re-detect the status the device must go back in normal mode and re-
entering in error detection mode.
Doc ID 13093 Rev 6
Detection mode functionality
17/31