VNP10N06FI STMicroelectronics, VNP10N06FI Datasheet - Page 4

• Manufacturer Part Number: VNP10N06FI
• Description: MOSFET POWER 60V 10A ISOWATT220
• Manufacturer: STMicroelectronics
• Series: OMNIFET™r
• Type: Low Sider

Specifications of VNP10N06FI

• Input Type: Non-Inverting
• Number Of Outputs: 1
• On-state Resistance: 150 mOhm
• Current - Peak Output: 10A
• Mounting Type: Through Hole
• Package / Case: TO-220FP
• Switch Type: Low Side
• Power Switch Family: VNP10N06FI
• Power Switch On Resistance: 150mOhm
• Output Current: 6A
• Mounting: Through Hole
• Supply Current: 150uA
• Package Type: ISOWATT220
• Pin Count: 3 +Tab
• Power Dissipation: 27W
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Voltage - Supply: -
• Operating Temperature: -
• Current - Output / Channel: -
• Lead Free Status / Rohs Status: Not Compliant

VNP10N06
4/11
PROTECTION FEATURES
During Normal Operation, the INPUT pin is
electrically connected to the gate of the internal
power MOSFET through a low impedance path
as soon as V
The device then behaves like a standard power
MOSFET and can be used as a switch from DC
to 50KHz. The only difference from the user’s
standpoint is that a small DC current (typically
150
supply the internal circuitry.
During turn-off of an unclamped inductive load
the output voltage is clamped to a safe level by
an integrated Zener clamp between DRAIN pin
and the gate of the internal Power MOSFET.
In this condition, the Power MOSFET gate is set
A) flows into the INPUT pin in order to
IN
> V
IH
.
to a voltage high enough to sustain the inductive
load current even if the INPUT pin is driven to 0V.
The device integrates an active current limiter
circuit which limits the drain current I
whatever the INPUT pin Voltage.
When the current limiter is active, the device
operates in the linear region, so power dissipation
may exceed the heatsinking capability. Both case
and junction temperatures increase, and if this
phase lasts long enough, junction temperature
may reach the overtemperature threshold T
If T
whatever the INPUT pin voltage. The device will
restart automatically when T
T
jrs
j
reaches T
jsh
, the device shuts down
j
has cooled down to
D
jsh
to I
.
lim