BTS5234G Infineon Technologies, BTS5234G Datasheet - Page 21

• Manufacturer Part Number: BTS5234G
• Description: IC HIGH SIDE PWR SWITCH PDSO-20
• Manufacturer: Infineon Technologies
• Series: PROFET®r
• Type: High Sider

Specifications of BTS5234G

• Input Type: Non-Inverting
• Number Of Outputs: 2
• On-state Resistance: 45 mOhm
• Current - Output / Channel: 3.3A
• Current - Peak Output: 28A
• Voltage - Supply: 4.5 V ~ 28 V
• Operating Temperature: -40°C ~ 150°C
• Mounting Type: Surface Mount
• Package / Case: DSO-20
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: BTS5234GT; SP000014727

For open load diagnosis in off state an external output pull-up resistor (
recommended. For calculation of the pull-up resistor, just the external leakage current
I
I
There is no internal leakage current from out to ground at BTS 5234G.
minimum supply voltage at which the open load diagnosis in off state must be ensured.
To reduce the stand-by current of the system, an open load resistor switch (
recommended.
4.3.3
The diagnosis signals have to be switched on by a high signal at sense enable pin (SEN).
See
Please note that the diagnosis is disabled, when no signal is provided at pin SEN.
Figure 17
The SEN pin circuit is designed equal to the input pin. Please refer to
The resistors
IS2 in case of reverse polarity and over voltage. Please refer to maximum ratings on
Page
The stand-by current of the BTS 5234G is minimized, when both input pins (IN1 and IN2)
and the sense enable pin (SEN) are on low level.
Data Sheet
leakage
leakage
Figure 17
SEN
8.
I
IS
and the open load threshold voltage
defines the leakage current in the complete system e.g. caused by humidity.
Sense Enable Function
t
sIS(SEN)
R
Timing of Sense Enable Signal
lim
for details on the timing between SEN pin and diagnosis signal
are recommended to limit the current through the sense pins IS1 and
t
dIS(SEN)
R
OL
=
V
---------------------------------------------------------- -
bb(min)
21
I
–
V
leakage
V
OUT(OL)
OUT(OL,max)
Smart High-Side Power Switch
t
sIS(SEN)
has to be taken into account.
t
dIS(SEN)
Figure 5
V1.0, 2004-01-23
V
BTS 5234G
bb(min)
t
t
for details.
R
S
OL
SEN.emf
OL
is the
) is
) is
I
IS
.