STLM75M2F STMicroelectronics, STLM75M2F Datasheet - Page 14

• Manufacturer Part Number: STLM75M2F
• Description: IC TEMP SNSR DGTL WATCHDOG 8SOIC
• Manufacturer: STMicroelectronics

Specifications of STLM75M2F

• Function: Temp Sensor, Watchdog
• Topology: ADC (Sigma Delta), Comparator, Register Bank
• Sensor Type: Internal
• Sensing Temperature: -55°C ~ 125°C
• Output Type: I²C™/SMBus™
• Output Alarm: Yes
• Output Fan: No
• Voltage - Supply: 2.7 V ~ 5.5 V
• Operating Temperature: -55°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 8-SOIC (3.9mm Width)
• Full Temp Accuracy: +/- 3 C
• Digital Output - Bus Interface: Serial (2-Wire, I2C)
• Digital Output - Number Of Bits: 12 bit
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 55 C
• For Use With: 497-10508 - BOARD EVAL FOR MEMS SENSORS497-10048 - BOARD EVAL ACCELEROMETER497-8848 - EVAL DAUGHTER STLM75 8-SOIC497-6238 - BOARD STLM75/STDS75/ST72F651
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-6926-2; STLM75M2F

Operation
2.5
Note:
2.6
14/40
Fault tolerance
For both comparator and interrupt modes, the alarm “fault tolerance” setting plays a role in
determining when the OS output will be activated. Fault tolerance refers to the number of
consecutive times an error condition must be detected before the user is notified. Higher
fault tolerance settings can help eliminate false alarms caused by noise in the system. The
alarm fault tolerance is controlled by the bits (4 and 3) in the configuration register. These
bits can be used to set the fault tolerance to 1, 2, 4, or 6 as shown in
these bits both default to logic '0'.
Table 2.
OS output will be asserted one t
condition remains.
Shutdown mode
For power-sensitive applications, the STLM75 offers a low-power shutdown mode. The SD
bit in the configuration register controls shutdown mode. When SD is changed to logic '1,'
the conversion in progress will be completed and the result stored in the temperature
register, after which the STLM75 will go into a low-power standby state. The OS output will
be cleared if the thermostat is operating in Interrupt mode and the OS will remain
unchanged in comparator mode. The 2-wire interface remains operational in shutdown
mode, and writing a '0' to the SD bit returns the STLM75 to normal operation.
FT1
0
0
1
1
FT0
0
1
0
1
Fault tolerance setting
STLM75 (consecutive faults)
1
2
4
6
Doc ID 13296 Rev 12
CONV
after fault tolerance is met, provided that the error
Power-up default
Comments
Table
2. At power-up,
STLM75