L5985 STMicroelectronics, L5985 Datasheet - Page 8

• Manufacturer Part Number: L5985
• Description: IC REG SW STEP DOWN 2A 8-VFQFPN
• Manufacturer: STMicroelectronics
• Type: Step-Down (Buck)r

Specifications of L5985

• Internal Switch(s): Yes
• Synchronous Rectifier: No
• Number Of Outputs: 1
• Voltage - Output: 0.6 ~ 18 V
• Current - Output: 2A
• Frequency - Switching: 250kHz ~ 1MHz
• Voltage - Input: 2.9 ~ 18 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 8-VFQFN, 8-VFQFPN
• Power - Output: 1.5W
• Output Voltage: 3 V
• Output Current: 2 A
• Input Voltage: 2.9 V to 18 V
• Switching Frequency: 220 KHz to 275 KHz
• Operating Temperature Range: - 40 C to + 150 C
• Mounting Style: SMD/SMT
• Duty Cycle (max): 100 %
• Low Dropout Operation: 100% duty cycle
• For Use With: 497-6387 - BOARD EVAL FOR L5985
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Functional description
4.1
8/37
Oscillator and synchronization
Figure 4
constant frequency clock. Its frequency depends on the resistor externally connect to FSW
pin. In case the FSW pin is left floating the frequency is 250 kHz; it can be increased as
shown in
To improve the line transient performance, keeping the PWM gain constant versus the input
voltage, the voltage feed forward is implemented by changing the slope of the sawtooth
according to the input voltage change (see
The slope of the sawtooth also changes if the oscillator frequency is increased by the
external resistor. In this way a frequency feed forward is implemented
keep the PWM gain constant versus the switching frequency (see
expression).
On the SYNCH pin the synchronization signal is generated. This signal has a phase shift of
180° with respect to the clock. This delay is useful when two devices are synchronized
connecting the SYNCH pin together. When SYNCH pins are connected, the device with
higher oscillator frequency works as Master, so the Slave device switches at the frequency
of the master but with a delay of half a period. This minimizes the RMS current flowing
through the input capacitor [see L5988D data sheet].
Figure 4.
The device can be synchronized to work at higher frequency feeding an external clock
signal. The synchronization changes the sawtooth amplitude, changing the PWM gain
(Figure
To minimize the change of the PWM gain, the free running frequency should be set (with a
resistor on FSW pin) only slightly lower than the external clock frequency. This pre-adjusting
of the frequency will change the sawtooth slope in order to get negligible the truncation of
sawtooth, due to the external synchronization.
5.c). This changing has to be taken into account when the loop stability is studied.
shows the block diagram of the oscillator circuit. The internal oscillator provides a
Figure 6
FSW
FSW
Oscillator circuit block diagram
by external resistor connected to ground.
Generator
Generator
Clock
Clock
Doc ID 13006 Rev 5
Figure
Synchronization
Synchronization
Generator
Generator
5.a).
Ramp
Ramp
Clock
Clock
Clock
Section 5.4
(Figure
SYNCH
SYNCH
Sawtooth
Sawtooth
5.b) in order to
for PWM gain
L5985