PVG3A502A01R00 Murata Electronics North America, PVG3A502A01R00 Datasheet - Page 8

• Manufacturer Part Number: PVG3A502A01R00
• Description: POT 5K OHM 3MM TRIM 1TRN SMD
• Manufacturer: Murata Electronics North America
• Series: PVG3r

Specifications of PVG3A502A01R00

• Resistance (ohms): 5K
• Power (watts): 0.25W, 1/4W
• Taper: Linear
• Tolerance: ±20%
• Temperature Coefficient: ±150ppm/°C
• Number Of Turns: Single
• Adjustment Type: Top Adjustment
• Mounting Type: Surface Mount
• Resistive Material: Cermet
• Package / Case: Square - 0.142" L x 0.134" W x 0.079" H (3.60mm x 3.40mm x 2.00mm)
• Resistance In Ohms: 5.00K
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 490-2254-2

9
!Note
!Note
74
No.
13
14
SMD Sealed Type/Lead Sealed Type Specifications and Test Methods
Specifications and Test Methods
Continued from the preceding page.
Low Temperature Operation
(Only for PVF2 and
PVM4A---B01)
Rotational Life
• Please read rating and !CAUTION (for storage and operating, rating, soldering and mounting, handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specification or transact the approval sheet for product specification before ordering.
Please read rating and !CAUTION (for storage and operating, rating, soldering and mounting, handling) in this PDF catalog to prevent smoking and/or burning, etc.
This catalog has only typical specifications. Therefore, you are requested to approve our product specification or to transact the approval sheet for product specificaion before ordering.
Item
The trimmer potentiometer shall be placed in a camber at a temperature of -25±3°C (-55±3°C for PVM4A---
B01series) 48±4 hours without loading. The trimmer potentiometer shall be removed from the chamber, and main-
tained at a temperature of 25±5°C for 5±1/6 hours
1)PV-- series
Full rated continuous working voltage not exceeding the maximum rated voltage shall be applied with the circuit
shown in the figure. The adjustment rotor (screw) shall be continuously cycled through not less than 90% of effec-
tive-electrical rotational angle (number of turns), at the rate of 1 cycle for 5 seconds minimum to 2.5 a minutes maxi-
mum for total of 200 cycles.
2) PVG3, PVG5series
The adjustment rotor (screw) shall be continuously cycled though not less than 90% of effective- electrical rotational
angle (number of turns), at the rate of 1 cycle for 5 seconds minimum to 2.5 minutes maximum for a total of 50 (100
for PVG5) cycles, without loading.
3) PVF2, PVM4A---B01series
The wiper shall be rotated over 90% of the effective rotational angle without loading at a speed of 10 cycles per
minute, for 100 cycles continuously.
End Terminal
Resistor 1
End Terminal
Figure-4
DC supply
End Terminal
Resistor 2 End Terminal
Test Methods
R50E12.pdf 02.9.5