ATICE50POD Atmel, ATICE50POD Datasheet - Page 55

• Manufacturer Part Number: ATICE50POD
• Description: REPLACEMENT POD FOR ICE40,ICE50
• Manufacturer: Atmel

Specifications of ATICE50POD

• Accessory Type: POD Replacement Kit
• For Use With/related Products: AVR ICE40 and ICE50
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

7.1
ICE50 User Guide
Enabling Trace
in AVR Studio
The ICE50 contains a 144-bit wide, 128K levels deep Trace Buffer. This document
describes the contents of the AVR Studio Trace Buffer view.
1. To enable Trace in AVR Studio select “Trace Normal” from the trace toolbar pull-
Figure 7-1. Enable Trace
2. In the active source window select Trace start and stop by pressing F8. Press F8
Figure 7-2. Start and Stop Trace
3. It is possible to have several start and stop points. Each pair of start and stop
down menu. See Figure 7-1.
once for Trace to start at this line. Press F8 twice for Trace to end at this line.
Press F8 three times to remove Trace. Alternatively the icons on the Trace tool-
bar menu can be used instead of F8. The hand is equal to Trace start and stop.
The hands with red marks will remove all Trace points. Trace on is marked with a
“1” while trace off is marked by a “1” with a red line across. See Figure 7-2.
points will have an unique number (Function ID). In Figure 7-3 two Trace
start/stop pair are shown (number 1 and 2).
Section 7
Rev. 2523A–AVR–11/02
Trace
7-1