DEMO9S08SG32AUTO Freescale Semiconductor, DEMO9S08SG32AUTO Datasheet - Page 2

• Manufacturer Part Number: DEMO9S08SG32AUTO
• Description: DEMO BOARD FOR MC9S08SG32
• Manufacturer: Freescale Semiconductor
• Type: MCUr

Specifications of DEMO9S08SG32AUTO

• Contents: *
• Processor To Be Evaluated: MC9S08Sx
• Data Bus Width: 8 bit
• Interface Type: RS-232, USB
• Silicon Manufacturer: Freescale
• Core Architecture: HCS08
• Core Sub-architecture: HCS08
• Silicon Core Number: MC9S08
• Silicon Family Name: S08SG
• Kit Contents: Board
• Rohs Compliant: Yes
• For Use With/related Products: MC9S08SG32
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

D E M O 9 S 0 8 S H 3 2 / S G 3 2
Q U I C K
Load and run the LED_DEMO Program
The steps below will show how to program the MCU using the CodeWarrior Development Studio for HC(S)08
Special Edition. The program loaded is a series of steps used to verify peripheral functionality.
1. Ensure the target board is connected and the LED_DEMO program is running. Refer above if necessary.
2. Copy and unzip the SCI_DEMO.zip file from the Support CD to the host PC. Make note of where the file is
3. Find and double-click the SCI_DEMO.mcp project file to open the project in CodeWarrior.
4. Ensure the P&E Multilink/Cyclone Pro build target is selected.
5. Open the MAIN.ASM file to inspect the demonstration code.
6. From the Project menu, select Debug or click the Debug button. The user may also press the F5 key.
7. Click the Connect button when the ICD - Connection Manager pops-up. Click Yes button at the Erase and
8. The SCI_DEMO application program loads into FLASH memory on the target.
9. Connect a serial cable (not provided) between the host PC and the COM port on the target board
10. Open AxIDE, or other terminal emulation program, and configure for 9600, 8, N, 1
11. Press the RESET button on the target board and observe a text display in the AxIDE window.
Troubleshooting
VDD LED does not light
•
•
•
Unable to program the target MCU using the USB-BDM
•
No display in terminal window
•
•
•
If the above Troubleshooting Tips fail to correct the problem, contact Axiom Manufacturing at
[e-mail]
stored during the unzip process.
Program Flash? Pop-up window.
Ensure PWR_SEL jumper is set to VB position (refer to Figure 1 above)
Ensure CodeWarrior is properly installed
Ensure USB drivers loaded when target board connected to PC
Follow troubleshooting steps under VDD LED above
Ensure COM_SEL jumpers are set to COM position (refer to Figure 1 above)
Ensure terminal program is configure to 9600, 8, N, 1
Ensure serial cable is securely attached to host PC and target board
S T A R T
G U I D E
for further assistance.
Axiom Manufacturing, 2006. All rights reserved
R E V
D O C - 0 4 2 1 - 0 2 0
1 . 1 ,
Spencer Ruggles
0 7 / 2 0 0 7