STICE-SYS001 STMicroelectronics, STICE-SYS001 Datasheet - Page 14

• Manufacturer Part Number: STICE-SYS001
• Description: EMULATOR FOR STM8
• Manufacturer: STMicroelectronics
• Series: STM8r
• Type: In-Circuit Debugger, Emulator, Programmerr

Specifications of STICE-SYS001

• Contents: Main Emulation Board (MEB), Target Emulation Board (TEB), Cables, Power Supply and Documentation
• For Use With/related Products: STM8
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: 497-10029

Emulation configuration
Note:
14/26
Right panel
●
●
●
●
Figure 7.
Front panel
●
●
Back panel
●
●
Figure 8.
Do not use the TEST connector on the front panel for in-circuit debugging. The connector for
ICD is located on the right panel, as shown in
Figure 9.
Three status LEDs
–
–
–
10-pin in-circuit programming/debugging connector (type HE10)
Two output triggers (see
Input trigger (see
10-pin probe analyzer input connector (see
Test connector (reserved)
External link connector (reserved)
Sliding door to access mode switch (reserved). Switch must be in Emul position.
Reset (Red) indicates that the chip is being reset.
Wait (Yellow) indicates that emulator is in halt or wait for interrupt mode.
Run (Green) indicates that the application is running
Right side panel
Front panel
Back panel
Output and input
Output and input
Doc ID 13332 Rev 3
triggers)
/ICP
Figure
triggers)
Section 3.2.4 on page
9.
16)
UM0406