HS1527KEPH60H Renesas Electronics America, HS1527KEPH60H Datasheet - Page 18

• Manufacturer Part Number: HS1527KEPH60H
• Description: EMULATOR BASE UNIT H8SX SERIES
• Manufacturer: Renesas Electronics America
• Type: Microcontrollerr

Specifications of HS1527KEPH60H

• Contents: E6000 Emulator and CD-ROM
• For Use With/related Products: H8SX/1520
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Check the location of pin 1 before inserting the MCU into the IC socket on the user system, as shown
in figure 8. After inserting the MCU, fasten the socket cover with the provided four screws (M2.6
6 mm; with four flat washers). Take special care, such as manually securing the IC socket soldered
area, to prevent the IC socket from being damaged by overtightening the screws or twisting the
components.
12
1. Check the location of pin 1 before inserting.
2. Use a Philips-type screwdriver whose head matches
3. The tightening torque must be 0.0785 N•m or less.
4. If the MCU does not operate correctly, cracks might have
Section 3 Installing the MCU to the User System
the screw head.
If the applied torque cannot be accurately measured,
stop tightening when the force required to turn the screw
becomes significantly greater than that needed when first
tightening. If a screw is tightened too much, the screw
head may break or an IC socket contact error may be
caused by a crack in the IC socket solder.
occurred in the solder. Check conduction with a tester
and re-solder the IC socket if necessary.
CAUTION
x