ST7FLI49MK1T6 STMicroelectronics, ST7FLI49MK1T6 Datasheet - Page 95

• Manufacturer Part Number: ST7FLI49MK1T6
• Description: MCU 8BIT SGL VOLT FLASH 32-LQFP
• Manufacturer: STMicroelectronics
• Series: ST7r

Specifications of ST7FLI49MK1T6

• Core Processor: ST7
• Core Size: 8-Bit
• Speed: 8MHz
• Connectivity: I²C
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 24
• Program Memory Size: 4KB (4K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 128 x 8
• Ram Size: 384 x 8
• Voltage - Supply (vcc/vdd): 2.4 V ~ 5.5 V
• Data Converters: A/D 10x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 32-LQFP
• Processor Series: ST7FLI4x
• Core: ST7
• Data Bus Width: 8 bit
• Data Ram Size: 384 B
• Interface Type: I2C
• Maximum Clock Frequency: 8 MHz
• Number Of Programmable I/os: 24
• Number Of Timers: 5
• Maximum Operating Temperature: + 125 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 10 bit, 10 Channel
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

ST7LITE49M
PWMX control status register (PWMxCSR)
Reset value: 0000 0000 (00h)
Bits 7:4= Reserved, must be kept cleared.
Bit 3 = OP_EN One-pulse mode enable bit
Bit 2 = OPEDGE One-pulse edge selection bit
Bit 1 = OPx PWMx output polarity bit
Bit 0 = CMPFx PWMx compare flag
Break control register (BREAKCR)
Reset value: 0000 0000 (00h)
Bit 7 = Reserved
This bit is read/write by software and cleared by hardware after a reset. This bit enables
the One-pulse feature for PWM2 and PWM3 (only available for PWM3CSR)
0: One-pulse mode disable for PWM2/3.
1: One-pulse mode enable for PWM2/3.
This bit is read/write by software and cleared by hardware after a reset. This bit selects
the polarity of the LTIC signal for One-pulse feature. This bit will be effective only if
OP_EN bit is set (only available for PWM3CSR)
0: Falling edge of LTIC is selected.
1: Rising edge of LTIC is selected.
This bit is read/write by software and cleared by hardware after a reset. This bit selects
the polarity of the PWM signal.
0: The PWM signal is not inverted.
1: The PWM signal is inverted.
This bit is set by hardware and cleared by software by reading the PWMxCSR register.
It indicates that the upcounter value matches the Active DCRx register value.
0: Upcounter value does not match DCRx value.
1: Upcounter value matches DCRx value.
7
0
7
0
BREDGE
0
BA
0
Doc ID 13562 Rev 3
BPEN
0
Read/write
Read/write
OP_EN
PWM3
OPEDGE
PWM2
On-chip peripherals
OPx
PWM1
CMPFx
PWM0
0
95/188
0