Z8F0813HJ005EG Zilog, Z8F0813HJ005EG Datasheet - Page 109

• Manufacturer Part Number: Z8F0813HJ005EG
• Description: IC Z8 ENCORE MCU FLASH 8K 28SSOP
• Manufacturer: Zilog
• Series: Encore!® XP®r

Specifications of Z8F0813HJ005EG

• Core Processor: Z8
• Core Size: 8-Bit
• Speed: 5MHz
• Connectivity: IrDA, UART/USART
• Peripherals: Brown-out Detect/Reset, LED, POR, PWM, WDT
• Number Of I /o: 24
• Program Memory Size: 8KB (8K x 8)
• Program Memory Type: FLASH
• Ram Size: 1K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 105°C
• Package / Case: 28-SSOP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Data Converters: -
• Other names: 269-4182; Z8F0813HJ005EG

PS025203-0405
1
0
Idle State
of Line
Clear To Send (CTS) Operation
MULTIPROCESSOR (9-bit) Mode
Figure 13.UART Asynchronous MULTIPROCESSOR Mode Data Format
4. Executes the IRET instruction to return from the interrupt-service routine and await
The CTS pin, if enabled by the CTSE bit of the UART Control 0 register, performs flow
control on the outgoing transmit datastream. The Clear To Send (CTS) input pin is sam-
pled one system clock before beginning any new character transmission. To delay trans-
mission of the next data character, an external receiver must deassert CTS at least one
system clock cycle before a new data transmission begins. For multiple character trans-
missions, this action is typically performed during Stop Bit transmission. If CTS deasserts
in the middle of a character transmission, the current character is sent completely.
The UART has a MULTIPROCESSOR (9-bit) mode that uses an extra (9th) bit for selec-
tive communication when a number of processors share a common UART bus. In MULTI-
PROCESSOR mode (also referred to as 9-Bit mode), the multiprocessor bit (
transmitted immediately following the 8-bits of data and immediately preceding the Stop
bit(s) as illustrated in Figure 13. The character format is:
In MULTIPROCESSOR (9-bit) mode, the Parity bit location (9th bit) becomes the Multi-
processor control bit. The UART Control 1 and Status 1 registers provide MULTIPRO-
CESSOR (9-bit) mode control and status information. If an automatic address matching
scheme is enabled, the UART Address Compare register holds the network address of the
device.
MULTIPROCESSOR (9-bit) Mode Receive Interrupts
When MULTIPROCESSOR mode is enabled, the UART only processes frames addressed
to it. The determination of whether a frame of data is addressed to the UART can be made
in hardware, software or some combination of the two, depending on the multiprocessor
configuration bits. In general, the address compare feature reduces the load on the CPU,
because it does not require access to the UART when it receives data directed to other
Start
more data.
Bit0
lsb
Bit1
Bit2
P R E L I M I N A R Y
Bit3
Data Field
Bit4
Bit5
Bit6
Z8 Encore!
msb
Bit7
Product Specification
MP
®
Z8F0823 Series
1
Stop Bit(s)
MP
2
) is
UART
92