DVK-BTM411 Laird Technologies, DVK-BTM411 Datasheet - Page 52

• Manufacturer Part Number: DVK-BTM411
• Description: BLUETOOTH EVAL BOARD BTM411
• Manufacturer: Laird Technologies
• Type: Transceiverr

Specifications of DVK-BTM411

• Frequency: 2.4GHz
• Wireless Frequency: 2.402 GHz to 2.48 GHz
• Interface Type: UART
• Data Rate: 2.1 Mbps
• Operating Voltage: 3 V to 3.3 V
• Antenna: Multilayer Ceramic Integrated
• Operating Temperature Range: - 30 C to + 70 C
• Output Power: 4 dBm
• Technology/ Type: Development Kit
• For Use With/related Products: BTM411
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: DVK-BTM411

BTM410/411
Bluetooth
AT COMMAND SET
REFERENCE
52 www.lairdtech.com
®
AT Data Module
Error Responses
Error
01
02
03
04
05
06
06
08
09
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
Description
Register not recognized
Value for register is out of range
Incoming call NOT pending
No call to connect to. This error code has meaning for ATO only
Syntax Error
Empty String
Device Class could not be stored
Invalid Device Class Code
Invalid Bluetooth Address
Could not set Service or Friendly name
PS Store Write
PS Store Read
Not Idle
Incorrect Mode
Already Scanning
Pairing is already in progress
Not USED
Not USED
Not USED
Not safe to write to Non-volatile Store - Ongoing Bluetooth Connection
Link Key Cache is Empty
Link Key Database is Full
Malloc returned NULL - Resource Issue
Remote Address same as Local Address
Connection Setup Fail, DSR Not asserted
Unauthenticated licence
Max Responses (See S Register 518) too high. Memory allocation error
The length of Pin in AT+BTK is too long
Invalid Ring count specified for S Register 0 or 100. If S0<>0 and S100<>0 then S0 must be < S100
ADC Error
Analogue Value cannot be read as it is set for output
Analogue Value cannot be written as it is set for input
S Register Value is invalid
Both L and R modifier cannot be specified in ATD command
Invalid Major Device Class – valid value in range 0x00 to 0x1F inclusive
Pairing in progress – Command cannot be actioned – try again later
Invalid Sniff parameter specified.
E.g. new Attempt value greater than MinInterval. Solution is to first increase MinInterval and re-enter
the Attempt value.
Get Remote Friendly name Failed
Failed to change mode to Multipoint
7 Bit mode requires parity to be even or odd
Stream Error
Stream Pending Error
Laird Technologies