EM260-DEV Ember, EM260-DEV Datasheet - Page 53

• Manufacturer Part Number: EM260-DEV
• Description: KIT DEV FOR EM260
• Manufacturer: Ember
• Series: InSightr
• Type: 802.15.4/Zigbeer

Specifications of EM260-DEV

• Frequency: 2.4GHz
• For Use With/related Products: EM260
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 636-1005

6.3.4
Name: version
Description: The command allows the Host to specify the desired EZSP version. This document describes
version 1 of the protocol. The response provides information about the firmware running on the EM260.
Command Parameters:
int8u desiredProtocolVersion
Response Parameters:
int8u protocolVersion
int8u stackType
int16u stackVersion
Name: getConfigurationValue
Description: Reads a configuration value from the EM260.
Command Parameters:
EzspConfigId configId
Response Parameters:
EzspConfigStatus status
int16u value
Name: setConfigurationValue
Description: Writes a configuration value to the EM260. Configuration values can be modified by the Host
after the EM260 has reset. Sending any command other than
rationValue
will respond with EZSP_CONFIG_INVALID_CALL.
Command Parameters:
EzspConfigId configId
int16u value
Response Parameters:
EzspConfigStatus status
Configuration Frames
or
addEndpoint
means that configuration values can no longer be modified and this command
The type of stack running on the EM260. The available EZSP
EZSP_CONFIG_SUCCESS if the value was read successfully,
ID: 0x00
The EZSP version the Host wishes to use.
The EZSP version the EM260 is using. If the EM260 does not
support the version requested by the Host, it will use the highest
version it does support.
commands and their parameters depend on the stack type. The
mesh stack is type 2.
The version number of the stack.
ID: 0x52
Identifies which configuration value to read.
EZSP_CONFIG_INVALID_ID if the EM260 does not recognize
configId
The configuration value.
ID: 0x53
Identifies which configuration value to change.
The new configuration value.
EZSP_CONFIG_SUCCESS if the configuration value was changed,
EZSP_CONFIG_OUT_OF_MEMORY if the new value exceeded the
available memory, EZSP_CONFIG_INVALID_VALUE if the new
value was out of bounds, EZSP_CONFIG_INVALID_ID if the EM260
does not recognize
configuration values can no longer be modified.
.
version
configId
,
getConfigurationValue
, EZSP_CONFIG_INVALID_CALL if
120-1003-000D
,
EM260
setConfigu-
53