MTCBA-C1-N16 Multi-Tech Systems, MTCBA-C1-N16 Datasheet - Page 26

• Manufacturer Part Number: MTCBA-C1-N16
• Description: MODEM ETHERNET
• Manufacturer: Multi-Tech Systems

Specifications of MTCBA-C1-N16

• Function: Transceiver, CDMA, Modem
• Modulation Or Protocol: CDMA2000
• Frequency: 800MHz, 1.9GHz
• Applications: Aeris Networks (USA)
• Interface: RS-232
• Data Rate - Maximum: 153.6 kbps
• Voltage - Supply: 9 V ~ 32 V
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: Q4976016

Fixed DTE Rate +IPR
Description:
Syntax:
DTE-DCE Local Flow Control +IFC
Description:
Syntax:
Values:
Multi-Tech Systems, Inc. CDMA C1 AT Commands Reference Guide (PN S000478C)
Chapter 8 – Communication
This command is used to specify the baud rate for the modem DATA port. The factory default
value is 115200.
Note:
At power-up, the interface rate is set to the value that was active when the last AT&W command
was used.
Note:
e.g., TCP App.
Command syntax: AT+IPR
This command is used to specify the UART flow control method. The factory default value is 2,2.
AT&F and AT&W are in effect. Software flow control is not supported.
Command syntax: AT+IFC=<Tx>,<Rx>
<Tx>
Command
AT+IPR?
Note: Read syntax.
AT+IPR=115200
Note: Set interface rate to 115200 bps
AT+IPR=?
Note: List of supported <rate> values,[(list
of fixed-only <rate> values)]
AT+IPR
Note: Set interface rate to factory default of
115200 bps
Command
AT+IFC=2,2
Note: Set values
AT+IFC
Note: Set factory default values
AT+IFC?
Note: Display current settings.
AT+IFC=?
Note: Display valid parameter ranges.
0
1
2
3
None
XON/XOFF
Hardware
XON/XOFF
Auto-baud (automatic detection of DTE rate) is not supported.
The use of baud rates below 9600 may affect the operability of some software features;
Commands
Transmit data flow control disabled.
Not Supported. Remove Xon (0x19) and Xoff (0x17) characters from data
stream.
Use RTS (Request To Send) signal (default)
Not Supported. Leave Xon (0x19) and Xoff (0x17) characters in data stream.
Possible Responses
OK
Note: New values set.
OK
+IFC: 2,2
OK
+IFC: (0-3),(0-2)
OK
Possible Responses
+IPR: 9600
OK
Note: Current rate is 9600 bps
OK
(),(300,600,1200,2400,4800,9600,
19200,38400,57600,115200,230400)
OK
Note: List of values showing possible baud rates
OK
Chapter 8 – Communication Commands
26