ATMEGA256RZBV-8CU Atmel, ATMEGA256RZBV-8CU Datasheet - Page 2

• Manufacturer Part Number: ATMEGA256RZBV-8CU
• Description: BUNDLE ATMEGA2560V/AT86RF230-ZU
• Manufacturer: Atmel
• Series: ATMEGAr

Specifications of ATMEGA256RZBV-8CU

• Frequency: 2.4GHz
• Modulation Or Protocol: 802.15.4 Zigbee
• Applications: ISM, ZigBee™
• Power - Output: 3dBm
• Sensitivity: -101dBm
• Voltage - Supply: 1.8 V ~ 3.6 V
• Current - Receiving: 15.5mA
• Current - Transmitting: 16.5mA
• Data Interface: PCB, Surface Mount
• Memory Size: 256kB Flash, 4kB EEPROM, 8kB RAM
• Antenna Connector: PCB, Surface Mount
• Package / Case: 100-TFBGA
• Wireless Frequency: 2.4 GHz
• Interface Type: SPI, USART
• Output Power: 3 dBm
• For Use With: ATAVRISP2 - PROGRAMMER AVR IN SYSTEMATJTAGICE2 - AVR ON-CHIP D-BUG SYSTEM
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Operating Temperature: -
• Data Rate - Maximum: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: ATmega256

2 Getting Started with the ATAVRRZ502 Accessory Kit
2.1 Unpacking the System
2.2 System Requirements
2.3 Quick Start Guide
2
AVR414
This section gives an introduction to what the ATAVRRZ502 Accessory Kit contains
and its system requirements. At the end brief instructions are given on how to get the
Accessory Kit up and running in the shortest amount of time.
Kit contents:
• (2 pcs) RZ502 Radio boards with SMA stub antennas.
• (2 pcs) ATmega1281V AVR
• Technical Library CD.
The minimum hardware and software requirements are:
• (2 pcs) STK®500
• (2 pcs) STK501
• (2 pcs) 9 pin RS-232 cable
• (2 pcs) 6-wire cable
• (2 pcs) 2-wire cable
• Power Supply for STK500.
• PC running AVR Studio
This section goes through how to get the RZ502 kit and evaluation application up and
running in the shortest amount of time.
1. Unpack the ATAVRRZ502 Accessory Kit and ensure that it contains all
2. Ensure that all the components listed in subsection 2.2 is available.
3. Go through the steps in section 4 to assemble the hardware. Repeat this step twice
4. Generate EEPROM file for each peer in the network using the HEXMaker
5. Program the ATmega1281 microcontroller by following the instructions in
6. Finally, a chat client is available to interface with the evaluation application just
components listed in subsection 2.1.
to build both peers.
application. How to use this application is described in subsection 5.1.
subsection 5.2. Repeat this step on both peers.
programmed into the AVR microcontroller. Go through the instructions in section 6
on how to setup and use the chat client.
to-RS232 bridge).
®
and with two available RS-232 ports (COM port or USB-
®
microcontroller in TQFP Package.
8051A-AVR-11/06