WM8351GEB/V Wolfson Microelectronics, WM8351GEB/V Datasheet - Page 283

• Manufacturer Part Number: WM8351GEB/V
• Description: Audio CODECs Audio CODEC plus pwr management
• Manufacturer: Wolfson Microelectronics

Specifications of WM8351GEB/V

• Number Of Adc Inputs: 2
• Number Of Dac Outputs: 2
• Conversion Rate: 48 KSPS
• Interface Type: Serial (2-Wire, 3-Wire, 4-Wire)
• Resolution: 12 bit
• Operating Supply Voltage: 3.7 V
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Package / Case: BGA
• Minimum Operating Temperature: - 25 C
• Number Of Channels: 2 ADC/2 DAC
• Supply Current: 260 uA
• Thd Plus Noise: - 83 dB
• Audio Codec Type: Stereo
• No. Of Adcs: 2
• No. Of Dacs: 2
• No. Of Input Channels: 8
• No. Of Output Channels: 6
• Adc / Dac Resolution: 24bit
• Adcs / Dacs Signal To Noise Ratio: 95dB
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

REGISTER
Production Data
w
ADDRESS
R168 (A8h)
Control 1
Charger
Battery
12:10
BIT
15
9
8
7
6
5
4
CHG_TRICKLE_TEMP_CHOKE
CHG_FAST_USB_THROTTLE
CHG_TRICKLE_USB_CHOKE
CHG_EOC_SEL[2:0]
CHG_RECOVER_T
CHG_END_ACT
CHG_FAST
CHG_ENA
LABEL
DEFAULT
000
1
0
0
0
0
0
0
CHG_ENA bit selects battery charger
current control
0 = Set battery charger current to zero
1 = Enable battery charge control
Protected by security key. Reset by state
machine. Default held in metal mask.
Selects what the end of charge current
should be set to
000 = 20mA
001 = 30mA
...
111 = 90mA
Protected by security key.
Enable trickle charge temperature
choking
0 = disable
1 = enable
Protected by security key. Reset by state
machine.
Enable USB current choking in trickle
charge
0 = disable
1 = enable
Protected by security key. Reset by state
machine.
Time constant adjust for charger choke
recovery (step-up):
0 = Step-up time constant is 180us
(allows faster recovery between
processor wakeups)
1 = Step-up time constant is >20ms
(outside audio band)
Protected by security key. Reset by state
machine.
Action to take when charging ends:
0 = Set charge current to 0
1 = Do nothing (leave charger on till
timeout)
Protected by security key. Reset by state
machine.
Enable fast charging.
0 = Fast charging cannot take place.
1 = Enable fast charging (will not start
until valid charging conditions are met).
Note: This register is held low and can
only be written to once the fast charge
ready signal has gone high.
Protected by security key. Reset by state
machine. Default held in metal mask.
Enable USB current throttling in fast
charge:
0 = Don't do any current throttling when
fast charging.
1 = Do current throttle while fast
charging.
(10mA steps)
DESCRIPTION
PD, March 2010, Rev 4.2
REFER TO
WM8351
283