L6470H STMicroelectronics, L6470H Datasheet - Page 54

• Manufacturer Part Number: L6470H
• Description: Motor / Motion / Ignition Controllers & Drivers 8 - 45V 7.0A 1/128 Microstepping SPI
• Manufacturer: STMicroelectronics
• Type: Micro Stepping Motor Driverr
• Series: -r

Specifications of L6470H

• Product: Stepper Motor Controllers / Drivers
• Operating Supply Voltage: 8 V to 45 V
• Supply Current: 0.5 mA
• Mounting Style: SMD/SMT
• Package / Case: HTSSOP-28
• Operating Temperature: - 40 C to + 125 C
• Applications: Stepper Motor Driver, 2 Phase
• Evaluation Tools: *
• Number Of Outputs: 1
• Current - Output: 3A
• Voltage - Load: 8 V ~ 45 V
• Voltage - Supply: 3.3V, 5V
• Mounting Type: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Programming manual
9.2.3
9.2.4
54/64
SetParam (PARAM, VALUE)
Table 38.
The SetParam command sets the PARAM register value equal to VALUE; PARAM is the
respective register address listed in
Some registers cannot be written (see
causes the command to be ignored and the WRONG_CMD flag to rise at the end of
command byte as like as unknown command code is sent (see paragraph
Some registers can only be written in particular conditions (see
write one of those registers when the conditions are not satisfied causes the command to be
ignored and the NOTPERF_CMD flag to rise at the end of last argument byte (see
paragraph
Any attempt to set an inexistent register (wrong address value) causes the command to be
ignored and WRONG_CMD flag to rise at the end of command byte as like as unknown
command code is sent.
GetParam (PARAM)
Table 39.
This command reads the current PARAM register value; PARAM is the respective register
address listed in
Returned value is the register one at the moment of SetParam command decoding. If
register values changes after this moment the response will not be accordingly updated.
Any attempt to read an inexistent register (wrong address value) causes the command to be
ignored and WRONG_CMD flag to rise at the end of command byte as like as unknown
command code is sent.
Bit 7
Bit 7
0
0
Bit 6
9.1.22
Bit 6
0
0
SetParam command structure
GetParam command structure
Table 11
).
Bit 5
0
Bit 5
1
Byte 2 (if needed)
Byte 1 (if needed)
Bit 4
. All registers can be read anytime.
Byte 2 (if needed)
Byte 1 (if needed)
Bit 4
Byte 0
Doc ID 16737 Rev 2
Byte 0
Bit 3
Table 11
Bit 3
Table 11
PARAM
Bit 2
PARAM
.
Bit 2
); any attempt to write one of those registers
Bit 1
Bit 1
Bit 0
Bit 0
Table 11
); any attempt to
From host
9.1.22
from host
to host
to host
to host
).
L6470