DRT2-ID32BV-1 Omron, DRT2-ID32BV-1 Datasheet - Page 109

• Manufacturer Part Number: DRT2-ID32BV-1
• Description: 32 In Vert MIL Connector PNP
• Manufacturer: Omron

Specifications of DRT2-ID32BV-1

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Connecting Communications Cables to General-purpose Slaves
88
3. Remove the exposed mesh shield, remove the aluminum tape from the sig-
4. Attach the crimp terminals to the lines and then cover any exposed areas
5. Orient the connector properly, loosen the line set screws, and then insert
6. Connectors without set screws do not require lines to be secured with
the other lines, but it is harder than the mesh shield and should be easily
identified.
nal and power lines, and strip the covering from the signal and power lines
to the proper length for the crimp terminal connectors. Twist together the
wires of each of the signal and power lines.
of the cable and lines with electrician's tape or heat-shrinking tubes.
the lines in order: Red, white, shield, blue, and then black.
screws as with previous connectors. Push up the orange tab and then in-
sert each line into the back of each hole.
Release the orange lever after inserting the lines, and gently pull each line
to check that it is securely connected to the connector.
There are colored stickers provided on the Master Unit and Slaves that
match the colors of the lines to be inserted. Check that the colors of the
lines and stickers match when wiring the connectors.
Note The colors used are as follows:
Blue
(CAN L)
Red
White
---
Black ( − V)
Color
Red (+V)
Power line, positive voltage
(+V)
Communications line, high
(CAN H)
Shield
Strip to match
the crimp
terminals.
White
(CAN H)
Shield
Signal
Shield wire
Section 5-2