16FL2CZ47A(F) Toshiba, 16FL2CZ47A(F) Datasheet - Page 2

• Manufacturer Part Number: 16FL2CZ47A(F)
• Description: DIODE HI EFF 300V 16A TO-220
• Manufacturer: Toshiba

Specifications of 16FL2CZ47A(F)

• Voltage - Forward (vf) (max) @ If: 1.3V @ 8A
• Voltage - Dc Reverse (vr) (max): 100V
• Current - Average Rectified (io): 16A
• Current - Reverse Leakage @ Vr: 50µA @ 100V
• Diode Type: Standard
• Speed: Fast Recovery =< 500ns, > 200mA (Io)
• Reverse Recovery Time (trr): 35ns
• Mounting Type: Through Hole
• Package / Case: TO-220-3 (Straight Leads)
• Product: Ultra Fast Recovery Rectifier
• Configuration: Dual Common Cathode
• Reverse Voltage: 100 V
• Forward Voltage Drop: 1.3 V at 8 A
• Recovery Time: 35 ns
• Forward Continuous Current: 16 A
• Max Surge Current: 88 A
• Reverse Current Ir: 50 uA
• Mounting Style: Through Hole
• Maximum Operating Temperature: + 150 C
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Capacitance @ Vr, F: -
• Lead Free Status / Rohs Status: Details

MARKING
Handling Precaution
The maximum ratings denote the absolute maximum ratings, which are rated values and must not be exceeded
during operation, even for an instant. The following are the general derating methods that we recommend when
you design a circuit with a device.
This rating specifies the non-repetitive peak current in one cycle of a 50-Hz sine wave, condition angle 180.
Therefore, this is only applied for an abnormal operation, which seldom occurs during the lifespan of the device.
We recommend that a device be used at a Tj of below 120°C under the worst load and heat radiation conditions.
Please refer to the Rectifiers databook for further information.
V
I
Characteristics
O
RRM
:
indicator
:
16DL2CZ
We recommend that the worst case voltage, including surge voltage, be no greater than 80% of the
maximum rating of V
circuit. V
account designing a device at low temperature.
We recommend that the worst case current be no greater than 80% of the maximum rating of I
Carry out adequate heat design. If you can’t design a circuit with excellent heat radiation, set the
margin by using an allowable Tamax-I
RRM
Part No. (or abbreviation code)
Lot No.
A line indicates
lead (Pb)-free package or
lead (Pb)-free finish.
has a temperature coefficient of 0.1%/°C. Take this temperature coefficient into
RRM
for a DC circuit and be no greater than 50% of that of V
O
curve.
2
Abbreviation Code
16DL2CZ
16FL2CZ
16DL2CZ47A,16FL2CZ47A
16DL2CZ47A
16FL2CZ47A
Part No.
RRM
2004-07-07
for an AC
O
.