DS3104GN Maxim Integrated Products, DS3104GN Datasheet - Page 24
DS3104GN
Manufacturer Part Number
DS3104GN
Description
Timers & Support Products SDH-SONET-Synchronou s Ethernet Line Card
Manufacturer
Maxim Integrated Products
Datasheet
1.DS3104GN.pdf
(136 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
DS3104GN+
Manufacturer:
Microsemi Consumer Medical Product Group
Quantity:
10 000
Part Number:
DS3104GN+
Manufacturer:
DALLAS
Quantity:
20 000
- Current page: 24 of 136
- Download datasheet (697Kb)
in revertive mode, ultra-fast switching could cause excessive reference switching when the highest priority input is
intermittent.
7.6.5 External Reference Switching Mode
In this mode the SRCSW input pin controls reference switching between two clock inputs. This mode is enabled by
setting the EXTSW bit to 1 in the
lock to input IC3 (if the priority of IC3 is nonzero in IPR2) or IC5 (if the priority of IC3 is zero) whether or not the
selected input has a valid reference signal. If the SRCSW pin is low, the T0 DPLL is forced to lock to input IC4 (if
the priority of IC4 is nonzero in IPR2) or IC6 (if the priority of IC4 is zero) whether or not the selected input has a
valid reference signal. During reset the default value of the EXTSW bit is latched from the SRCSW pin. If external
reference switching mode is enabled during reset, the default frequency tolerance (
to 80ppm rather than the normal default of 9.2ppm.
In external reference switching mode the device is simply a clock switch, and the T0 DPLL is forced to lock onto the
selected reference whether or not it is valid. Unlike forced reference selection (Section 7.6.3) this mode controls the
PTAB1:SELREF field directly and is, therefore, not affected by the state of the MCR3:REVERT bit. During external
reference switching mode, only PTAB1:SELREF is affected; the REF1, REF2, and REF3 fields in the
registers continue to indicate the highest, second-highest, and third-highest priority valid inputs chosen by the
automatic selection logic. External reference switching mode only affects the T0 DPLL.
7.6.6 Output Clock Phase Continuity During Reference Switching
If phase build-out is enabled (PBOEN = 1 in MCR10) or the DPLL frequency limit (
30ppm, the device always complies with the GR-1244-CORE requirement that the rate of phase change must be
less than 81ns per 1.326ms during reference switching.
19-4627; Rev 7; 8/10
________________________________________________________________________________________ DS3104-SE
MCR10
register. In this mode, if the SRCSW pin is high, the T0 DPLL is forced to
D LIMIT
1 5
D
5
LIMIT) is set to less than
registers) is configured
24 of 136
PTAB
Related parts for DS3104GN
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
Ds3104 Line Card Timing Ic With Synchronous Ethernet Support
Manufacturer:
Maxim Integrated Products, Inc.
Datasheet:
Part Number:
Description:
Line Card Timing Ic With Synchronous Ethernet Support
Manufacturer:
Maxim Integrated Products, Inc.
Datasheet:
Part Number:
Description:
MAX7528KCWPMaxim Integrated Products [CMOS Dual 8-Bit Buffered Multiplying DACs]
Manufacturer:
Maxim Integrated Products
Datasheet:
Part Number:
Description:
Single +5V, fully integrated, 1.25Gbps laser diode driver.
Manufacturer:
Maxim Integrated Products
Datasheet:
Part Number:
Description:
Single +5V, fully integrated, 155Mbps laser diode driver.
Manufacturer:
Maxim Integrated Products
Datasheet:
Part Number:
Description:
VRD11/VRD10, K8 Rev F 2/3/4-Phase PWM Controllers with Integrated Dual MOSFET Drivers
Manufacturer:
Maxim Integrated Products
Datasheet:
Part Number:
Description:
Highly Integrated Level 2 SMBus Battery Chargers
Manufacturer:
Maxim Integrated Products
Datasheet:
Part Number:
Description:
Current Monitor and Accumulator with Integrated Sense Resistor; ; Temperature Range: -40°C to +85°C
Manufacturer:
Maxim Integrated Products
Part Number:
Description:
TSSOP 14/A°/RS-485 Transceivers with Integrated 100O/120O Termination Resis
Manufacturer:
Maxim Integrated Products
Part Number:
Description:
TSSOP 14/A°/RS-485 Transceivers with Integrated 100O/120O Termination Resis
Manufacturer:
Maxim Integrated Products
Part Number:
Description:
QFN 16/A°/AC-DC and DC-DC Peak-Current-Mode Converters with Integrated Step
Manufacturer:
Maxim Integrated Products
Part Number:
Description:
TDFN/A/65V, 1A, 600KHZ, SYNCHRONOUS STEP-DOWN REGULATOR WITH INTEGRATED SWI
Manufacturer:
Maxim Integrated Products
Part Number:
Description:
Integrated Temperature Controller f
Manufacturer:
Maxim Integrated Products
Part Number:
Description:
SOT23-6/I°/45MHz to 650MHz, Integrated IF VCOs with Differential Output
Manufacturer:
Maxim Integrated Products
Part Number:
Description:
SOT23-6/I°/45MHz to 650MHz, Integrated IF VCOs with Differential Output
Manufacturer:
Maxim Integrated Products