LAN83C185-JD SMSC, LAN83C185-JD Datasheet - Page 16

• Manufacturer Part Number: LAN83C185-JD
• Description: Ethernet ICs Lo Pwr 10/100 3.3V PHY
• Manufacturer: SMSC

Specifications of LAN83C185-JD

• Ethernet Connection Type: 10 Base-T, 100 Base-TX
• Minimum Operating Temperature: 0 C
• Mounting Style: SMD/SMT
• Product: Ethernet Transceivers
• Number Of Transceivers: 1
• Standard Supported: 100BASE-TX, 10BASE-T
• Data Rate: 10 MB, 100 MB
• Supply Voltage (max): 3.6 V
• Supply Voltage (min): 3 V
• Supply Current (max): 1 mA, 19 mA
• Maximum Operating Temperature: + 70 C
• Package / Case: TQFP-64
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Chapter 4 Architecture Details
Revision 0.8 (06-12-08)
4.1
4.2
4.2.1
4.2.2
Top Level Functional Architecture
100Base-TX Transmit
Functionally, the PHY can be divided into the following sections:
The data path of the 100Base-TX is shown in
100M Transmit Data across the MII
The MAC controller drives the transmit data onto the TXD bus and asserts TX_EN to indicate valid
data. The data is latched by the PHY’s MII block on the rising edge of TX_CLK. The data is in the
form of 4-bit wide 25MHz data.
4B/5B Encoding
The transmit data passes from the MII block to the 4B/5B encoder. This block encodes the data from
4-bit nibbles to 5-bit symbols (known as “code-groups”) according to
is mapped to 16 of the 32 possible code-groups. The remaining 16 code-groups are either used for
control information or are not valid.
The first 16 code-groups are referred to by the hexadecimal values of their corresponding data nibbles,
0 through F. The remaining code-groups are given letter designations with slashes on either side. For
example, an IDLE code-group is /I/, a transmit error code-group is /H/, etc.
MAC
100Base-TX transmit and receive
10Base-T transmit and receive
MII interface to the controller
Auto-negotiation to automatically determine the best speed and duplex possible
Management Control to read status registers and write control registers
Converter
NRZI
RJ45
MII 25 MHz by 4 bits
TX_CLK
(for MII)
NRZI
MLT-3
Converter
Figure 4.1 100Base-TX Data Path
MLT-3
100M
High Performance Single Chip Low Power 10/100 Ethernet Physical Layer Transceiver (PHY)
PLL
CAT-5
DATASHEET
125 Mbps Serial
MII
MLT-3
MLT-3
16
by 4 bits
25MHz
Driver
Figure
Tx
4.1. Each major block is explained below.
Encoder
4B/5B
MLT-3
Magnetics
25MHz by
5 bits
Table
4.1. Each 4-bit data-nibble
Scrambler
and PISO
SMSC LAN83C185
Datasheet