LAN9303-ABZJ Standard Microsystem (Smsc), LAN9303-ABZJ Datasheet - Page 135

• Manufacturer Part Number: LAN9303-ABZJ
• Description: Ethernet Switch 3-Port 10Mbps/100Mbps 56-Pin QFN EP
• Manufacturer: Standard Microsystem (Smsc)

Specifications of LAN9303-ABZJ

• Package: 56QFN EP
• Phy/transceiver Interface: MII/RMII
• Number Of Primary Switch Ports: 3
• Maximum Data Rate: 100 Mbps
• Vlan Support: Yes
• Power Supply Type: Analog
• Minimum Single Supply Voltage: 3 V
• Maximum Single Supply Voltage: 3.6 V
• Maximum Supply Current: 0.19(Typ) A

Small Form Factor Three Port 10/100 Managed Ethernet Switch with Single MII/RMII/Turbo MII
Datasheet
SMSC LAN9303/LAN9303i
12.3.2
LED Function Definitions when LED_FUN[1:0] = 11b
When
When
The LED pins are push-pull drivers.
The LED polarity does not depend upon the
pin is driven high when the function signal is high, and is driven low when the function signal is low.
The input buffers and pull-ups are disabled on the shared GPIO/LED pins.
TX_EN Port 0 - Non-stretched TX_EN signal from the Switch Fabric to the external MII pins.
Note: Link indication does not affect this function.
RX_DV Port 0 - Non-stretched RX_DV signal from the external MII pins to the Switch Fabric.
Note: Link indication does not affect this function.
TX_EN Port 1 - Non-stretched TX_EN signal from the Switch Fabric to the PHY.
Note: Link indication does not affect this function.
RX_DV Port 1 - Non-stretched RX_DV signal from the PHY to the Switch Fabric.
Note: Link indication does not affect this function.
TX_EN Port 2 - Non-stretched TX_EN signal from the Switch Fabric to the PHY.
Note: Link indication does not affect this function.
RX_DV Port 2 - Non-stretched RX_DV signal from the PHY to the Switch Fabric.
Note: Link indication does not affect this function.
LED Function 1-0 (LED_FUN[1:0])
LED Function 1-0 (LED_FUN[1:0])
DATASHEET
is 11b, the following LED rules apply:
is 11b, the following LED function definitions apply:
135
led_pol_strap[5:0]
LED polarity hard-straps. The LED
Revision 1.4 (07-07-10)