ISP1504ABS,118 NXP Semiconductors, ISP1504ABS,118 Datasheet - Page 47

• Manufacturer Part Number: ISP1504ABS,118
• Description: RF Transceiver USB ULPI TRANSCEIVER
• Manufacturer: NXP Semiconductors

Specifications of ISP1504ABS,118

• Number Of Transceivers: 1
• Esd Protection: YeskV
• Operating Supply Voltage (typ): Not RequiredV
• Operating Temperature Classification: Industrial
• Operating Supply Voltage (max): Not RequiredV
• Operating Supply Voltage (min): Not RequiredV
• Pin Count: 32
• Mounting: Surface Mount
• Operating Temperature (max): 85C
• Operating Temperature (min): -40C
• Operating Supply Voltage: 1.65 V to 3.6 V
• Mounting Style: SMD/SMT
• Package / Case: HVQFN-32
• Lead Free Status / RoHS Status: Compliant
• Other names: 935278308118 ISP1504ABS-T

NXP Semiconductors
ISP1504A_ISP1504C_3
Product data sheet
9.14 Aborting transfers
9.15 Avoiding contention on the ULPI data bus
The ISP1504 supports aborting transfers on the ULPI bus. For details, refer to UTMI+ Low
Pin Interface (ULPI) Specification Rev. 1.1, Section 3.8.4 .
Because the ULPI data bus is bidirectional, avoid situations in which both the link and the
PHY simultaneously drive the data bus.
The following points must be considered while implementing the data bus drive control on
the link.
After power-up and clock stabilization, default states are as follows:
When the ISP1504 wants to take control of the data bus to initiate a data transfer, it
changes the DIR value from LOW to HIGH.
At this point, the link must disable its output buffers. This must be as fast as possible so
the link must use a combinational path from DIR.
The ISP1504 will not immediately enable its output buffers, but will delay the enabling of
its buffers until the next clock edge, avoiding bus contention.
When the data transfer is no longer required by the ISP1504, it changes DIR from HIGH to
LOW and starts to immediately turn off its output drivers. The link senses the change of
DIR from HIGH to LOW, but delays enabling its output buffers for one CLOCK cycle,
avoiding data bus contention.
•
•
•
The ISP1504 drives DIR to LOW.
The data bus is input to the ISP1504.
The ULPI link data bus is output, with all data bus lines driven to LOW.
Rev. 03 — 7 April 2008
ISP1504A; ISP1504C
ULPI HS USB OTG transceiver
© NXP B.V. 2008. All rights reserved.
46 of 82