ISP1507FBS,518 NXP Semiconductors, ISP1507FBS,518 Datasheet - Page 12

no-image

ISP1507FBS,518

Manufacturer Part Number
ISP1507FBS,518
Description
RF Transceiver USB 2.0 ULPI TRNSCVR
Manufacturer
NXP Semiconductors
Datasheet

Specifications of ISP1507FBS,518

Number Of Transceivers
1
Esd Protection
YeskV
Power Supply Requirement
Single
Operating Supply Voltage (typ)
3.3V
Operating Temperature Classification
Industrial
Operating Supply Voltage (max)
3.6V
Operating Supply Voltage (min)
3V
Dual Supply Voltage (typ)
Not RequiredV
Dual Supply Voltage (max)
Not RequiredV
Dual Supply Voltage (min)
Not RequiredV
Mounting
Surface Mount
Operating Temperature (max)
85C
Operating Temperature (min)
-40C
Lead Free Status / RoHS Status
Compliant
Other names
935285499518 ISP1507FBS-T
NXP Semiconductors
ISP1507E_ISP1507F_1
Product data sheet
7.9.3 RREF
7.9.4 DP and DM
7.9.5 ID
7.9.6 CPGND
7.9.7 C_A and C_B
Resistor reference analog I/O pin. A resistor, R
and GND, as shown in
biases internal analog circuitry. Less accurate resistors cannot be used and will render the
ISP1507 unusable.
DP (data plus) and DM (data minus) are USB differential data pins. These must be
connected to the D+ and D pins of the USB receptacle.
For OTG implementations, the ID (identification) pin is connected to the ID pin of the
micro-USB receptacle. As defined in On-The-Go Supplement to the USB 2.0 Specification
Rev. 1.3 , the ID pin dictates the initial role of the link. If ID is detected as HIGH, the link
must assume the role of a peripheral. If ID is detected as LOW, the link must assume a
host role. Roles can be swapped at a later time by using HNP.
If the ISP1507 is not used as an OTG PHY, but as a standard USB host or peripheral PHY,
the ID pin must be connected to REG3V3.
CPGND indicates the analog ground for the on-board charge pump. CPGND must always
be connected to ground, even when the charge pump is not used.
The C_A and C_B pins are to connect the flying capacitor of the charge pump. The output
current capability of the charge pump depends on the value of the capacitor used, as
shown in
For details, see
If the charge pump is not used, C_A and C_B must be left floating (not connected).
Fig 4.
STP
Table
Charge pump capacitor
3. For maximum efficiency, place capacitors as close as possible to pins.
Section
Section
Rev. 01 — 28 May 2008
16.
ISP1507
16. This provides an accurate voltage reference that
C_A
C_B
V
BUS
ISP1507E; ISP1507F
RREF
C cp(C_A)-(C_B)
, must be connected between RREF
004aab086
I L
ULPI HS USB OTG transceiver
© NXP B.V. 2008. All rights reserved.
11 of 78

Related parts for ISP1507FBS,518