STM32W108HBU6 STMicroelectronics, STM32W108HBU6 Datasheet - Page 134

• Manufacturer Part Number: STM32W108HBU6
• Manufacturer: STMicroelectronics

Specifications of STM32W108HBU6

• Operating Temperature (min): -40C
• Operating Temperature (max): 85C
• Processing Unit: Microprocessor
• Operating Supply Voltage (min): 1.18V
• Operating Supply Voltage (typ): 1.25V
• Operating Supply Voltage (max): 1.32V
• Package Type: VFQFPN EP
• Pin Count: 40
• Mounting: Surface Mount
• Rad Hardened: No
• Lead Free Status / Rohs Status: Supplier Unconfirmed

General-purpose timers
134/208
●
●
●
●
●
Figure 46. Gating timer 2 with enable of timer 1
Using one timer to start the other timer
In this example, the enable of Timer 2 is set with the update event of Timer 1. Refer to
Figure 44
zero) on the divided internal clock as soon as Timer 1 generates the update event.
When Timer 2 receives the trigger signal its TIM_CEN bit is automatically set and the
counter counts until 0 is written to the TIM_CEN bit in the TIM2_CR1 register. Both counter
clock frequencies are divided by 3 by the prescaler compared to CK_INT (fCK_CNT =
fCK_INT/3).
●
●
●
●
●
Reset Timer 2 by writing 1 in the TIM_UG bit (TIM2_EGR register).
Initialize Timer 2 to 0xE7 by writing 0xE7 in the Timer 2 counter (TIM2_CNTL).
Enable Timer 2 by writing 1 in the TIM_CEN bit (TIM2_CR1 register).
Start Timer 1 by writing 1 in the TIM_CEN bit (TIM1_CR1 register).
Stop Timer 1 by writing 0 in the TIM_CEN bit (TIM1_CR1 register).
Configure Timer 1 in master mode to send its update event as trigger output
(TIM_MMS = 010 in the TIM1_CR2 register).
Configure the Timer 1 period (TIM1_ARR register).
Configure Timer 2 to get the input trigger from Timer 1 (TIM_TS = 000 in the
TIM2_SMCR register).
Configure Timer 2 in trigger mode (TIM_SMS = 110 in the TIM2_SMCR register).
Start Timer 1: Write 1 in the TIM_CEN bit (TIM1_CR1 register).
for connections. Timer 2 starts counting from its current value (which can be non-
Doc ID 16252 Rev 7
STM32W108CB, STM32W108HB