EWIXP465BAET Intel, EWIXP465BAET Datasheet - Page 75

• Manufacturer Part Number: EWIXP465BAET
• Manufacturer: Intel

Specifications of EWIXP465BAET

• Core Operating Frequency: 667MHz
• Operating Supply Voltage (typ): 1.3/1.5/2.5/3.3V
• Operating Supply Voltage (max): 1.575/2.7/3.465V
• Operating Supply Voltage (min): 1.235/2.3/3.135V
• Package Type: BGA
• Pin Count: 544
• Mounting: Surface Mount
• Operating Temperature (max): 85C
• Operating Temperature (min): -40C
• Operating Temperature Classification: Industrial
• Lead Free Status / Rohs Status: Compliant

Package Information
Table 16.
May 2005
75
ETHC_COL
ETHC_CRS
NOTE: This table discusses all features supported on the Intel
† For a legend of the Type codes, see
†† Please refer to Intel
Name
see
Table 1 on page
MII/SMII Interfaces (Sheet 8 of 8)
®
IXP45X and Intel
Power
Reset
on
Z
Z
14.
†
Reset
VI
VI
Table 10 on page
®
†
IXP46X Product Line of Network Processors Developer’s Manual for information on how to select the interface desired
Software
Enables
Normal
Reset
After
Until
VI
VI
46.
Software
Enables
Normal
After
®
VI
VI
IXP45X and Intel
Type
I
I
†
MII Mode of Operation:
Asserted by the PHY when a collision is detected by the PHY. This MAC contains hardware
hashing capabilities local to the interface.
SMII Mode of Operation:
Not used.
When this interface is disabled via the NPE-C Ethernet soft fuse (refer to the Expansion Bus
Controller chapter of the Intel
Developer’s Manual) and is not being used a system desing, this interface/signal is not required
for any connection.
Asserted by the PHY when the transmit medium or receive medium are active. De-asserted
when both the transmit and receive medium are idle. Remains asserted throughout the duration
of collision condition. PHY asserts CRS asynchronously and de-asserts synchronously with
respect to ETHC_RXCLK.
This MAC contains hardware hashing capabilities local to the interface.
Should be pulled high through a 10-KΩ resistor when not being utilized in the system or when in
SMII mode of operation.
®
• When NPE C is configured in MII mode of operation and the signal is not being used, it
• When NPE C is configured in SMII mode of operation, this signal must be pulled high
IXP46X Product Line of Network Processors. For details on feature support listed by processor,
should be pulled low through a 10-KΩ resistor.
through a 10-KΩ resistor.
Intel
®
IXP45X and Intel
®
IXP45X and Intel
®
Description
IXP46X Product Line of Network Processors Datasheet
®
IXP46X Product Line of Network Processors
Document Number:
306261-002