BOXD865PERL Intel, BOXD865PERL Datasheet - Page 47

• Manufacturer Part Number: BOXD865PERL
• Manufacturer: Intel

Specifications of BOXD865PERL

• Lead Free Status / Rohs Status: Supplier Unconfirmed

✏
1.13.2.1
1.13.2.2
NOTE
The use of Resume on Ring and Wake from USB technologies from an ACPI state requires an
operating system that provides full ACPI support.
ATX12V-compliant power supplies can turn off the system power through system control. When
an ACPI-enabled system receives the correct command, the power supply removes all non-standby
voltages.
When resuming from an AC power failure, the computer returns to the power state it was in before
power was interrupted (on or off). The computer’s response can be set using the Last Power State
feature in the BIOS Setup program’s Boot menu.
CAUTION
The processor fan must be connected to the processor fan connector, not to a chassis fan
connector. Connecting the processor fan to a chassis fan connector may result in onboard
component damage that will halt fan operation.
Table 12 summarizes the fan connector function/operation.
Table 12.
For information about
The power connector locations
The power connector signal names
The BIOS Setup program’s Boot menu
The ATX specification
Connector
Processor fan
Front and rear
chassis fans
Voltage regulator
fan
Power Connector
Fan Connectors
Fan Connector Function/Operation
Description
• +12 V DC connection for a processor fan or active fan heatsink.
• Fan is on in the S0 or S1 state.
• Wired to a fan tachometer input of the hardware monitoring and fan control ASIC.
• Closed-loop fan control that can adjust the fan speed or switch the fan on or off as
• +12 V DC connection for a system or chassis fan.
• Fan is on in the S0 or S1 state.
• Wired to a fan tachometer input of the hardware monitoring and fan control ASIC.
• Closed-loop fan control that can adjust the fan speed or switch the fan on or off as
• +12 V DC connection for a system or chassis fan.
• Fan is on in the S0 or S1 state.
• Wired to a fan tachometer input of the hardware monitoring and fan control ASIC.
Fan is off when the system is off or in the S3, S4, or S5 state.
needed. (Optional)
Fan is off when the system is off or in the S3, S4, or S5 state.
needed.
Fan is off when the system is off or in the S3, S4, or S5 state.
Refer to
Figure 21, page 65
Table 33, page 67 and Table 30, page 66
Table 73, page 118
Section 1.4, page 17
Product Description
47