EP4CE55F23C7 Altera, EP4CE55F23C7 Datasheet - Page 184

• Manufacturer Part Number: EP4CE55F23C7
• Description: IC CYCLONE IV FPGA 55K 484FBGA
• Manufacturer: Altera
• Series: CYCLONE® IV Er

Specifications of EP4CE55F23C7

• Number Of Logic Elements/cells: 55856
• Number Of Labs/clbs: 3491
• Total Ram Bits: 2340000
• Number Of I /o: 324
• Voltage - Supply: 1.15 V ~ 1.25 V
• Mounting Type: Surface Mount
• Operating Temperature: 0°C ~ 85°C
• Package / Case: 484-FBGA
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Number Of Gates: -

8–18
Cyclone IV Device Handbook, Volume 1
f
f
1
Programming Serial Configuration Devices
Serial configuration devices are non-volatile, flash memory-based devices. You can
program these devices in-system with the USB-Blaster™ or ByteBlaster™ II download
cables. Alternatively, you can program them with the Altera Programming Unit
(APU), supported third-party programmers, or a microprocessor with the SRunner
software driver.
You can perform in-system programming of serial configuration devices through the
AS programming interface. During in-system programming, the download cable
disables device access to the AS interface by driving the nCE pin high. Cyclone IV
devices are also held in reset by a low level on nCONFIG. After programming is
complete, the download cable releases nCE and nCONFIG, allowing the pull-down
and pull-up resistors to drive V
To perform in-system programming of a serial configuration device through the AS
programming interface, you must place the diodes and capacitors as close as possible
to the Cyclone IV device. You must ensure that the diodes and capacitors maintain a
maximum AC voltage of 4.1 V
If you want to use the setup shown in
of a serial configuration device and single- or multi-device AS configuration, you do
not require a series resistor on the DATA line at the near end of the serial configuration
device. The existing diodes and capacitors are sufficient.
Altera has developed the Serial FlashLoader (SFL), a JTAG-based in-system
programming solution for Altera serial configuration devices. The SFL is a bridge
design for the Cyclone IV device that uses its JTAG interface to access the EPCS JIC
(JTAG Indirect Configuration Device Programming) file and then uses the AS
interface to program the EPCS device. Both the JTAG interface and AS interface are
bridged together inside the SFL design.
For more information about implementing the SFL with Cyclone IV devices, refer to
AN 370: Using the Serial FlashLoader with the Quartus II
For more information about the USB-Blaster download cable, refer to the
Download Cable User
cable, refer to the
ByteBlaster II Download Cable User
Guide. For more information about the ByteBlaster II download
Chapter 8: Configuration and Remote System Upgrades in Cyclone IV Devices
(Figure
CC
and GND, respectively.
Figure 8–6
8–6).
to perform in-system programming
Guide.
Software.
© December 2010 Altera Corporation
USB-Blaster
Configuration