A80960CA25 Intel, A80960CA25 Datasheet - Page 9

• Manufacturer Part Number: A80960CA25
• Description: IC MPU I960CA 25MHZ 168-PGA
• Manufacturer: Intel

Specifications of A80960CA25

• Processor Type: i960
• Features: CA suffix, 32-Bit with DMA, 1K Cache
• Speed: 25MHz
• Voltage: 5V
• Mounting Type: Surface Mount
• Package / Case: 168-PGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 802884

A31:2
D31:0
BE3:0
W/R
ADS
Name
Type
H(Z)
R(Z)
H(Z)
R(Z)
H(Z)
R(1)
H(Z)
R(0)
H(Z)
R(1)
S(L)
I/O
Table 3. 80960CA Pin Description — External Bus Signals (Sheet 1 of 3)
O
O
O
O
S
S
S
S
ADDRESS BUS carries the physical address’ upper 30 bits. A31 is the most
significant address bit; A2 is the least significant. During a bus access, A31:2 identify
all external addresses to word (4-byte) boundaries. The byte enable signals indicate
the selected byte in each word. During burst accesses, A3:2 increment to indicate
successive data cycles.
DATA BUS carries 32-, 16- or 8-bit data quantities depending on bus width configu-
ration. The least significant bit of the data is carried on D0 and the most significant on
D31. When the bus is configured for 8-bit data, the lower 8 data lines, D7:0 are used.
For 16-bit data bus widths, D15:0 are used. For 32-bit bus widths the full data bus is
used.
BYTE ENABLES select which of the four bytes addressed by A31:2 are active during
an access to a memory region configured for a 32-bit data-bus width. BE3 applies to
D31:24; BE2 applies to D23:16; BE1 applies to D15:8 BE0 applies to D7:0.
For accesses to a memory region configured for a 16-bit data-bus width, the
processor uses the BE3, BE1 and BE0 pins as BHE, A1 and BLE respectively.
For accesses to a memory region configured for an 8-bit data-bus width, the
processor uses the BE1 and BE0 pins as A1 and A0 respectively.
WRITE/READ is asserted for read requests and deasserted for write requests. The
W/R signal changes in the same clock cycle as ADS. It remains valid for the entire
access in non-pipelined regions. In pipelined regions, W/R is not guaranteed to be
valid in the last cycle of a read access.
ADDRESS STROBE indicates a valid address and the start of a new bus access.
ADS is asserted for the first clock of a bus access.
32-bit bus:
16-bit bus:
8-bit bus:
BE3
BE2
BE1
BE0
BE3
BE2
BE1
BE0
BE3
BE2
BE1
BE0
–Byte Enable 3
–Byte Enable 2
–Byte Enable 1
–Byte Enable 0
–Byte High Enable (BHE)
–Not used (driven high or low)
–Address Bit 1 (A1)
–Byte Low Enable (BLE)
–Not used (driven high or low)
–Not used (driven high or low)
–Address Bit 1 (A1)
–Address Bit 0 (A0)
Description
80960CA-33, -25, -16
–enable D31:24
–enable D23:16
–enable D15:8
–enable D7:0
–enable D15:8
–enable D7:0
5