CS42L55-DNZ Cirrus Logic Inc, CS42L55-DNZ Datasheet - Page 24

• Manufacturer Part Number: CS42L55-DNZ
• Description: IC CODEC STER H-HDPN AMP 36-QFN
• Manufacturer: Cirrus Logic Inc
• Type: Stereo Audior

Specifications of CS42L55-DNZ

• Data Interface: Serial
• Resolution (bits): 24 b
• Number Of Adcs / Dacs: 1 / 1
• Sigma Delta: Yes
• Dynamic Range, Adcs / Dacs (db) Typ: 95 / 99
• Voltage - Supply, Analog: 1.65 V ~ 2.71 V
• Voltage - Supply, Digital: 1.65 V ~ 2.71 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 36-QFN
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: 598-1506 - BOARD EVAL FOR CS42L55 CODEC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

24
4.2.1
4.2.2
Pseudo-Differential Inputs
The CS42L55 implements a pseudo-differential input stage. The AINxREF inputs are intended to be used
as a pseudo-differential reference signal. This feature provides 0 noise rejection with single-ended sig-
nals.
put stage, including a recommended stereo pseudo-differential input topology. If pseudo-differential input
functionality is not required, simply leave the AINxREF pin floating.
Automatic Level Control (ALC)
When enabled, the ALC monitors the analog input signal after the digital attenuator. The ALC then detects
when peak levels exceed the maximum threshold settings and first lowers the PGA gain settings and then
increases the digital attenuation levels at a programmable attack rate and maintains the resulting level
below the maximum threshold.
When input signal levels fall below the minimum threshold, digital attenuation levels are decreased first
and the PGA gain is then increased at a programmable release rate and maintains the resulting level
above the minimum threshold.
Attack and release rates are affected by the ADC soft ramp/zero cross settings and sample rate, Fs. ALC
soft ramp and zero cross dependency may be independently enabled/disabled.
Recommended settings: Best level control may be realized with the fastest attack and slowest release
setting with soft ramp enabled in the control registers.
Notes:
1. When ALC x is enabled and the PGAxVOL[5:0] is set to +12 dB, the ADCxATT[7:0] should not be set
2. The maximum desired gain must be set in the PGAxVOL register. The ALC will only apply the gain
3. The ALC maintains the output signal between the MIN and MAX thresholds. As the input signal level
Right Input
Referenced Control
PGAxMUX ...........................
Left Input
below 0 dB.
set in PGAxVOL.
changes, the level-controlled output may not always be the same but will always fall between the
thresholds.
GND
GND
Figure 10
(differential traces)
(differential traces)
//
//
//
//
shows a basic diagram outlining the internal implementation of the pseudo-differential in-
Register Location
“PGA x Input Select” on page 49
Figure 10. Stereo Pseudo-Differential Input
1 µF
1 µF
1 µF
1 µF
AIN1REF
AIN2REF
AIN1A
AIN2B
26
27
25
24
+
+
-
-
common mode rejection at input of PGA reduces
PGA A
PGA B
PGAAMUX=’0'b
PGABMUX=’1'b
external system noise
CS42L55
DS773F1