SU2200RMXLTNET APC, SU2200RMXLTNET Datasheet - Page 36

• Manufacturer Part Number: SU2200RMXLTNET
• Description: UPS - Uninterruptible Power Supplies APC Smart-UPS XL 2200VA RM 5U 208V
• Manufacturer: APC

Specifications of SU2200RMXLTNET

• Power Rating: 1600 W
• Output Voltage Rating: 208 V
• Number Of Outlets: 5
• Interface Port: DB-9 RS-232, SmartSlot
• Runtime (full Load): 10 min
• Runtime (half Load): 34 min
• Topology: Online
• Tower / Rackmount: Rackmount
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

3. Refer to Figure 5-21. Connect the output wiring as shown. Secure
5.3.4 Installation of New Rear Panels
Before closing up the back of the unit, make sure that all wiring has
been properly installed:
1. Input wiring should be connected to the last two screw terminals
2. Output wiring should be connected to the center two screw termi-
Make sure all ground wires (green) are securely fastened to a ground
screw.
Install the Output Panel
1. Slide the output panel into position as shown in Figure 5-22. Fas-
2. Make sure there are a few inches of slack output cable tucked in-
3. Tighten the cable clamp. The clamp will prevent strain on the con-
34
the ground wire (green) to one of the ground holes with a green
ground screw from the hardware bag.
at the right of the terminal block .
nals of the terminal block .
ten the panel to the UPS with 2 screws from the hardware bag.
side the unit.
nections if the output cable is accidentally pulled.