SU2200RMXLTNET APC, SU2200RMXLTNET Datasheet - Page 42

• Manufacturer Part Number: SU2200RMXLTNET
• Description: UPS - Uninterruptible Power Supplies APC Smart-UPS XL 2200VA RM 5U 208V
• Manufacturer: APC

Specifications of SU2200RMXLTNET

• Power Rating: 1600 W
• Output Voltage Rating: 208 V
• Number Of Outlets: 5
• Interface Port: DB-9 RS-232, SmartSlot
• Runtime (full Load): 10 min
• Runtime (half Load): 34 min
• Topology: Online
• Tower / Rackmount: Rackmount
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

6. Hold the label and harness together. Align them against the rack
7. Slide the rack mount wire harness bracket onto the UPS as shown
Connect the Wire Harness Assembly to the UPS
Electrical connection between the wire harness assembly and the UPS
is accomplished through the use of the four in-line connectors on the
wire harness assembly and the corresponding connectors inside the
UPS. Carefully follow the procedure below to ensure that the connec-
tions are made properly.
1. Refer to Figure 5-26 for connector numbers.
2. Retrieve one of the four-wire, yellow jumper harnesses (Figure 3-1,
40
mount wire harness bracket so that the screws line up with the
wire harness installation holes. (See Figure 5-27) Tighten the
screws while making sure the label stays in place.
in Figure 5-27. Make sure the metal tabs slide over the edge of the
UPS housing as shown. The tabs will hold the bracket in place
while the wire harness connections are made.
NOTE: Engage the connectors by holding one connector firmly in
each hand, and fitting them together. Be sure to seat the connec-
tors fully in place - they lock together with a click.
item #9). Plug the “female” end of the jumper harness into connec-
tor #4. Connect the “male” end of the jumper harness to the 4-pin
plug located inside the UPS. (Connector
in Figure 5-25)