TE28F400CVT80 Intel, TE28F400CVT80 Datasheet - Page 12

• Manufacturer Part Number: TE28F400CVT80
• Manufacturer: Intel

Specifications of TE28F400CVT80

• Cell Type: NOR
• Density: 4Mb
• Access Time (max): 80ns
• Interface Type: Parallel
• Boot Type: Top
• Address Bus: 19/18Bit
• Operating Supply Voltage (typ): 3.3/5V
• Operating Temp Range: -40C to 85C
• Package Type: TSOP
• Sync/async: Asynchronous
• Operating Temperature Classification: Industrial
• Operating Supply Voltage (min): 3/4.5V
• Operating Supply Voltage (max): 3.6/5.5V
• Word Size: 8/16Bit
• Number Of Words: 512K/256K
• Supply Current: 70mA
• Mounting: Surface Mount
• Pin Count: 48
• Lead Free Status / Rohs Status: Not Compliant

4-MBIT SmartVoltage BOOT BLOCK FAMILY
12
WP#
BYTE#
V
V
GND
NC
CC
PP
Symbol
INPUT
INPUT
Type
WRITE PROTECT: Provides a method for unlocking the boot block in a system
without a 12 V supply.
When WP# is at logic low, the boot block is locked, preventing program and
erase operations to the boot block. If a program or erase operation is attempted
on the boot block when WP# is low, the corresponding status bit (bit 4 for
program, bit 5 for erase) will be set in the status register to indicate the operation
failed.
When WP# is at logic high, the boot block is unlocked and can be
programmed or erased.
NOTE: This feature is overridden and the boot block unlocked when RP# is at
V
BYTE# ENABLE: Not available on 28F004B. Controls whether the device
operates in the byte-wide mode (x8) or the word-wide mode (x16). BYTE# pin
must be controlled at CMOS levels to meet the CMOS current specification in the
standby mode.
When BYTE# is at logic low, the byte-wide mode is enabled, where data is
read and programmed on DQ
address that decodes between the upper and lower byte. DQ
during the byte-wide mode.
When BYTE# is at logic high, the word-wide mode is enabled, where data is
read and programmed on DQ
DEVICE POWER SUPPLY: 5.0 V
PROGRAM/ERASE POWER SUPPLY: For erasing memory array blocks or
programming data in each block, a voltage either of 5 V
be applied to this pin. When V
against Program and Erase commands.
GROUND: For all internal circuitry.
NO CONNECT: Pin may be driven or left floating.
HH
Table 2. 28F400/004 Pin Descriptions (Continued)
. See Section 3.4 for details on write protection.
SEE NEW DESIGN RECOMMENDATIONS
0
0
PP
–DQ
–DQ
Name and Function
< V
7
15
PPLK
and DQ
10%, 3.3
.
all blocks are locked and protected
15
/A
0.3 V, 2.7 V–3.6 V (BE/CE only)
–1
becomes the lowest order
10% or 12 V
8
–DQ
14
are tri-stated
5% must