ADN2817 Analog Devices, Inc., ADN2817 Datasheet - Page 16

• Manufacturer Part Number: ADN2817
• Description: Continuous Rate 10 Mbps To 2.7gb/s Clock And Data Recovery Ics
• Manufacturer: Analog Devices, Inc.

ADN2817/ADN2818
JITTER SPECIFICATIONS
The ADN2817/ADN2818 CDR is designed to achieve the best
bit-error-rate (BER) performance and exceeds the jitter transfer,
generation, and tolerance specifications proposed for SONET/SDH
equipment defined in the Telcordia® Technologies specification.
Jitter is the dynamic displacement of digital signal edges from
their long-term average positions, measured in unit intervals
(UI), where 1 UI = 1 bit period. Jitter on the input data can
cause dynamic phase errors on the recovered clock sampling
edge. Jitter on the recovered clock causes jitter on the
retimed data.
The following sections briefly summarize the specifications
of jitter generation, transfer, and tolerance in accordance with
the Telcordia document (GR-253-CORE, Issue 3, September
2000) for the optical interface at the equipment level and the
ADN2817/ADN2818 performance with respect to those
specifications.
JITTER GENERATION
The jitter generation specification limits the amount of jitter
that can be generated by the device with no jitter and wander
applied at the input. For OC-48 devices, the band-pass filter
has a 12 kHz high-pass cutoff frequency with a roll-off of
20 dB/decade, and a low-pass cutoff frequency of at least
20 MHz. The jitter generated must be less than 0.01 UI rms,
and must be less than 0.1 UI p-p.
JITTER TRANSFER
The jitter transfer function is the ratio of the jitter on the output
signal to the jitter applied on the input signal vs. the frequency.
This parameter measures the limited amount of the jitter on an
input signal that can be transferred to the output signal (see
Figure 26).
Rev. 0 | Page 16 of 36
JITTER TOLERANCE
The jitter tolerance is defined as the peak-to-peak amplitude of
the sinusoidal jitter applied on the input signal, which causes a
1 dB power penalty. This is a stress test intended to ensure that
no additional penalty is incurred under the operating
conditions (see Figure 27).
0.1
15.00
1.50
0.15
ACCEPTABLE
RANGE
f
JITTER FREQUENCY (kHz)
0
Figure 27. SONET Jitter Tolerance Mask
JITTER FREQUENCY (kHz)
Figure 26. Jitter Transfer Curve
f
C
f
1
f
2
SLOPE = –20dB/DECADE
f
3
SLOPE = –20dB/DECADE
f
4