STTS751 STMicroelectronics, STTS751 Datasheet - Page 17

• Manufacturer Part Number: STTS751
• Description: 2.25 V low-voltage local digital temperature sensor
• Manufacturer: STMicroelectronics

www.DataSheet4U.com
STTS751
4.6
Table 15.
Note:
ADDR
(hex)
03
R/W
R/W
Configuration register
The STTS751 configuration register is read/write and controls the functionality of
temperature measurements. It is located at address 03h. The configuration register bits
function as described below.
Configuration register
Description
MASK1: [bit 7]
RUN/STOP: [bit 6]
The RUN/STOP bit controls temperature conversions by the ADC. When this bit is 0, the
ADC converts temperatures in continuous mode, at a rate as selected by the Conversion
Rate register
thus reducing current supply significantly.
The device can still be accessed via the SMBus while in standby mode.
When RUN/STOP is 1 and the one-shot register is written to, the ADC will execute a
temperature measurement and then return to standby mode.
[bit 5]: This bit must always be 0.
RFU: [bit 4] Not used - reserved.
Configuration
Register
0: EVENT is enabled. Any out-of-limit condition asserts the EVENT pin (active low).
1: EVENT is disabled.
0: Device is running in continuous conversion mode.
1: Device is in standby mode drawing minimum power.
(Section
MASK1 RUN/STOP
b7
4.7). When the RUN/STOP bit is 1, the ADC will be in standby mode,
b6
Doc ID 16483 Rev 5
b5
0
RFU
b4
Tres1
b3
Tres0
b2
STTS751 register summary
RFU
b1
RFU
b0
Power-up
default
(hex)
00
17/36