MD3331-D32-V3Q18 M-Systems Inc., MD3331-D32-V3Q18 Datasheet - Page 42

no-image

MD3331-D32-V3Q18

Manufacturer Part Number
MD3331-D32-V3Q18
Description
Mobile Diskonchip Plus 128Mbits 1.8V I/o
Manufacturer
M-Systems Inc.
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
MD3331-D32-V3Q18-X
Manufacturer:
SIPEX
Quantity:
7 500
9.2.2 Multiplexed Interface
With a multiplexed interface, Mobile DiskOnChip Plus requires the signals shown in Figure 15 below.
9.3
9.3.1 Standard Interface
Mobile DiskOnChip Plus uses standard SRAM-like control signals, which should be connected as follows:
42
Connecting Signals
Address (A[12:0]) – Connect these signals to the host address bus.
Data (D[15:0]) – Connect these signals to the host data bus.
Write (WE#) and Output Enable (OE#) – Connect these signals to the host WR# and RD# signals,
respectively.
Chip Enable (CE#) – Connect this signal to the memory address decoder.
Chip Identification (ID[0:1]) –Both signals must be connected to GND if only one Mobile DiskOnChip
Plus is being used. If more than one, refer to Section 9.6 for more information on cascaded configuration.
Power-On Reset In (RSTIN#) – Connect this signal to the host Power-On Reset signal.
Busy (BUSY#) – Connect this signal to an input port. It indicates when the device is ready for first access
after hardware reset.
Interrupt (IRQ#) – Connect this signal to the host interrupt to release the host of this task and improve
performance.
Byte High Enable (BHE#) – This signal definition is compatible with 16 bit platforms that use the
BHE#/BLE# protocol. This signal is only relevant during the boot phase.
Hardware Lock (LOCK#) – This signal prevents the use of the write protect key to disable the protection.
8/16 Bit Configuration (IF_CFG) – This signal is required for configuring the device for 8 or 16-bit access
mode. When negated, the device is configured for 8-bit access mode. When asserted, 16-bit access mode is
operative.
Output Enable
Address/Data
W rite Enable
Chip Enable
Chip ID
AVD#
Reset
0.1 uF
Figure 15: Multiplexed System Interface
ID0
RSTIN#
AD[15:0]
OE#
AVD#
CE#
W E#
Data Sheet, Rev. 1.7
10 nF
Mobile DiskOnChip
VCC
3.3 V
0.1 uF
VSS
Plus
BUSY#
LOCK#
10 nF
VCCQ
1.8V/3.3V
IRQ#
Mobile DiskOnChip Plus 16/32MByte 1.8V I/O
.
.
.
1-20KOhm
Busy
95-SR-000-10-8L

Related parts for MD3331-D32-V3Q18