UPD77111 NEC, UPD77111 Datasheet - Page 26
![no-image](/images/manufacturer_photos/0/4/470/nec_sml.jpg)
UPD77111
Manufacturer Part Number
UPD77111
Description
16-BIT FIXED-POINT DIGITAL SIGNAL PROCESSORS
Manufacturer
NEC
Datasheet
1.UPD77111.pdf
(80 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
UPD77111F1-002-CN1
Manufacturer:
SAMSUNG
Quantity:
96 887
Part Number:
UPD77111F1-002-CN1
Manufacturer:
NEC
Quantity:
20 000
5.2.2 Host reboot
0xBFFF. Areas 0x0200 through 0x0FFF and 0x4000 through 0xBFFF cannot be rebooted all at once.
by calling this address after setting the following parameter:
5.3 Signature Operation
verified. The signature operation performs a specific arithmetic operation on the data in the instruction RAM booted
up, and returns the result to a register. Perform the signature operation in advance on the device when it is operating
normally, and repeat the signature operation later to check whether the data in RAM is correct by comparing the
operation result with the previous result. If the results are identical, there is no problem.
Note that the operation cannot be performed on the areas 0x0200 through 0x0FFF and 0x4000 through 0xBFFF at
the same time. The operation result is stored in register R7.
6. STANDBY MODES
consumption can be reduced.
6.1 HALT Mode
stopped to reduce the current consumption.
interrupt, the contents of the internal registers and memory are retained. It takes several 10 system clocks to release
the HALT mode when the HALT mode is released using an interrupt.
clock. The clock output from the CLKOUT pin is as follows.
operation (i.e., the duty factor is not 50%).
26
An instruction code is obtained via the host interface and transferred to the instruction RAM.
With the PD77110, the host reboot mode is used to boot up the instruction RAM from addresses 0x4000 through
The entry address of the PD77110 is 0x6, and that of the PD77111 and 77112 is 0x5. Host reboot is executed
• R7L : Number of instruction steps for rebooting
• DP3: First address of instruction memory to be loaded
The PD77110 has a signature operation function so that the contents of the internal instruction RAM can be
The entry address is 0x9. Execute the operation by calling this address after setting the following parameter.
• R7L: Number of instruction steps for operation
• DP3: First address of instruction memory for operation
Two standby modes are available. By executing the corresponding instruction, each mode is set and the power
To set this mode, execute the HALT instruction. In this mode, functions other than clock circuit and PLL are
To release the HALT mode, use an interrupt or hardware reset. When releasing the HALT mode using an
In the HALT Mode, the clock circuit of the PD77111 family supplies the following clock as the internal system
The clock output from the CLKOUT pin, however, has a high-level width that is equivalent to 1 cycle of the normal
•
•
PD77110: 1/8 of internal system clock
PD77111, 77112: 1/l of internal system clock (l = integer from 1 to 16, specified by mask option)
Data Sheet U12801EJ4V0DS00
PD77110, 77111, 77112