NL10276AC24_02 NEC, NL10276AC24_02 Datasheet - Page 26

• Manufacturer Part Number: NL10276AC24_02
• Description: TFT COLOR LCD MODULE
• Manufacturer: NEC

26
GENERAL CAUTION
Do not touch an inverter --on which is stuck a caution label-- while the LCD module is under the operation,
because of dangerous high voltage.
Please input serial communication signals (CNTDAT, CNTCLK and CNTSTB) once, only when contents of
CNTDAT change.
If the input of the serial communication signals is continued, the LCD panel would be damaged.
Please refer to "Item FUNCTIONS (2)" about the detail of serial communication timings.
(1) Caution when taking out the module
(2) Cautions for handling the module
(3) Cautions for the operation
(4) Cautions for the atmosphere
(5) Cautions for the module characteristics
(6) Other cautions
WARNING
ATTENTION
q Pick the pouch only, when taking out module from a shipping package.
q As the electrostatic discharges may break the LCD module, handle the LCD module with care. Peel a
w As the LCD panel and back-light element are made from fragile glass material, impulse and pressure
e As the surface of polarizer is very soft and easily scratched, use a soft dry cloth without chemicals for
r Do not pull the interface connectors in or out while the LCD module is operating.
t Put the module display side down on a flat horizontal plane.
y Handle connectors and cables with care.
q When the module is operating, do not lose CLK, Hsync, or Vsync signals. If any one of these signals is
w Obey the supply voltage sequence. If wrong sequence is applied, the module would be damaged.
e Connect the variable resistor or fixed resistor (10 k
q Dew drop atmosphere should be avoided.
w Do not store and / or operate the LCD module in a high temperature and/or humidity atmosphere.
q Do not apply fixed pattern data signal to the LCD module at product aging. Applying fixed pattern for
q Do not disassemble and / or reassemble LCD module.
w Do not re-adjust variable resistor or switch etc.
e When returning the module for repair or etc., Please pack the module not to be broken.
protection sheet off from the LCD panel surface as slowly as possible.
to the LCD module should be avoided.
cleaning.
lost, the LCD panel would be damaged.
resistors are not connected, the life of fluorescent lamp would be short.
Storage in an electro-conductive polymer packing pouch and under relatively low temperature atmos-
phere is recommended.
a long time may cause image sticking.
We recommend to use the original shipping packages.
or less) to the pin of BRTH and BRTL. If the
NL10276AC24-02