NL10276AC30_09 NEC, NL10276AC30_09 Datasheet - Page 25

• Manufacturer Part Number: NL10276AC30_09
• Description: TFT COLOR LCD MODULE
• Manufacturer: NEC

6.3.2 Environment
6.3.3 Characteristics
6.3.4 Other
General characteristics for the LCD
x Dewdrop atmosphere must be avoided.
y Do not operate or store in high temperature or high humidity atmosphere. Keep the product in
z Do not operate in high magnetic field. Circuit boards may be broken down by it.
{ Use an original protection sheet on the product surface (polarizer). Adhesive type protection sheet
x Do not display the fixed pattern for a long time because it may cause image sticking. Use a screen
y The display color may be changed by viewing angle because of the use of condenser sheet in the
z Optical characteristics may be changed by input signal timings.
{ This module uses cold cathode fluorescent lamps. The lifetime of lamps is shortened conspicuously at
x All GND, GNDB, VDD and VDDB terminals should be used without a non-connected line.
y Do not disassemble a product or adjust volume without permission of NEC Corporation.
z See 'REPLACEMENT MANUAL FOR LAMP HOLDER SET', if customer would like to replace
{ Pay attention not to insert waste materials inside of products, if customer uses screwnails.
| Pack the product with original shipping package, because of avoidance of some damages during
} Not only the module but also the equipment that used the module should be packed and transported as
The following items are neither defects nor failures.
∗ ∗ ∗ ∗ Response time, luminance and color may be changed by ambient temperature.
∗ ∗ ∗ ∗ The LCD may be seemed luminance non-uniformity, flicker, vertical seam or small spot
∗ ∗ ∗ ∗ Optical characteristics (e.g. luminance, display uniformity, etc.) gradually is going to
by display patterns.
change depending on operating time, and especially low temperature, because the LCD has
cold cathode fluorescent lamps.
low and high temperatures.
antistatic pouch in room temperature, because of avoidance for dusts and sunlight, if customer stores
the product.
should be avoided, because it may change color or properties of the polarizer.
saver, if the fixed pattern is displayed on the screen.
backlight unit.
backlight lamps.
transportation, when customer returns it to NEC Corporation for repair and so on.
the module becomes vertical. Otherwise, there is the fear that a display dignity decreases by an impact
or vibrations."
DOD-M-0578
NEC Corporation
25/28