NL10276BC30-04F NEC, NL10276BC30-04F Datasheet - Page 22
![no-image](/images/manufacturer_photos/0/4/470/nec_sml.jpg)
NL10276BC30-04F
Manufacturer Part Number
NL10276BC30-04F
Description
TFT COLOR LCD MODULE
Manufacturer
NEC
Datasheet
1.NL10276BC30-04F.pdf
(27 pages)
18. GENERAL CAUTIONS
! ! ! !
(1) Caution when taking out the module
(2) Cautions for handling the module
Because next figures and sentences are very important, please understand these contents as follows.
! ! ! !
CAUTIONS
a. Pick a pouch only, when taking out the module from a carrier box.
a. As the electrostatic discharges may break the LCD module, handle the LCD module with care
b.
c. As the surface of polarizer is very soft and easily scratched, use a soft dry cloth without chemicals
d. Do not pull the interface connectors in or out while the LCD module is operating.
e. Put the module display side down on a flat horizontal plane.
f. Handle connectors and cables with care.
g. When the module is operating, do not lose CLK, HS, or Vsync signal. If any one or more of these
h. The torque for mounting screw should never exceed 0.392 N・m (4kgf・cm).
k. Do not give the stress to interface connectors. The module may become function deficiency by a
i. Don’t push or rub the surface of LCD module.
j. The LCD module should be mounted in strong body such as magnesium alloy. If the press or twist are
If you do, the scratches or the rubbing marks may be left on the surface of the module.
signals is lost, the LCD panel would be damaged.
CAUTION
Do not touch an inverter –on which a caution label is stucked-while the
LCD module is under the operation, because of dangerous high voltage.
added to the module, the display may have un-uniformity image. When the module is mounted to
customer chassis, please evaluate the display condition carefully.
against electrostatic discharges.
pressure to the LCD module should be avoided.
for cleaning.
contact defective and damages. Pay attention to handling at the time of matching connector
connection and in the connection condition.
This figure is a mark that you will get an electric shock when you make a mistake to
operate.
This figure is a mark that you will get hurt when you make a mistake to operate.
As the LCD panel and backlight element are made from fragile glass material, impulse and
This figure is a mark that you will get hurt and/or the module will have
damages when you make a mistake to operate.
NEC Corporation
DOD-M-0002
22/26