S25FL129P Meet Spansion Inc., S25FL129P Datasheet - Page 67

• Manufacturer Part Number: S25FL129P
• Description: 128-mbit Cmos 3.0 Volt Flash Memory With 104-mhz Spi Serial Peripheral Interface Multi I/o Bus
• Manufacturer: Meet Spansion Inc.

20. Revision History
November 2, 2009 S25FL129P_00_04
Revision 01 (May 26, 2009)
Revision 02 (June 22, 2009)
Quad Page Programming
Configuration Register
Data Protection Modes
Accelerated Programming Operation
Read Identification (RDID)
Read Status Register (RDSR)
Read Configuration Register (RCR)
Write Registers (WRR)
Parameter Sector Erase (P4E, P8E)
Sector Erase (SE)
Release from Deep Power-down
(RES)
Release from Deep Power-down and
Read Electronic Signature (RES)
OTP Regions
Initial Delivery State
AC Characteristics
Physical Dimensions
Revision 03 (October 14, 2009)
Global
Connection Diagrams
Ordering Information
Valid Combinations
Physical Dimensions
DC Characteristics
AC Characteristics
Section
D a t a
Initial release.
Corrected description.
Removed the Note in the bottom of the page.
Added Suggested cross setting table.
Corrected description for Software Protected Mode.
Added Note.
Corrected description.
Added statement for operating clock frequency.
Corrected figure.
Added statement for operating clock frequency.
Added reference section.
Added Note for Hardware Protect Mode.
Removed all occurrences of Quad operations.
Corrected description.
Added Note.
Corrected description.
Added Note.
Added Note.
Corrected description for ESN.
Added ESN table.
Added description for the Rock Register.
Corrected description of Note.
Added BGA package.
Changed datasheet designation from Advanced Information to Preliminary
Changed all references to RDID clock rate from 40 to 50 MHz
Added note regarding exposed central pad on bottom of package to the WSON connection diagram
Added “5 x 5 pin configuration” to Figure 2.3 title
Added 6 x 4 pin configuration BGA connection diagram
Added 20, 21, 30, and 31 model numbers for BGA packages
Added Automotive In-Cabin temperature ordering option
Added Low-Halogen material option
Changed valid BGA model number combinations to 20, 21, 30, and 31
Changed valid BGA material option to Low-Halogen
Added Automotive In-Cabin temperature valid combinations for all packages
Added Note 2 regarding contact factory for availability of Automotive In-Cabin temperature grade
parts
Added FAC024 BGA package
Added Note 1 indicating that I
Added min and max values for Sector Erase Time (256 KB)
S h e e t
( P r e l i m i n a r y )
S25FL129P
CSB1
maximum value only applies to Industrial temperature grade parts
Description
67