s29gl128n Meet Spansion Inc., s29gl128n Datasheet - Page 57

• Manufacturer Part Number: s29gl128n
• Description: 3.0 Volt-only Page Mode Flash Memory Featuring 110 Nm Mirrorbit ?rocess Technology
• Manufacturer: Meet Spansion Inc.

S29GL-N_00_B3 October 13, 2006
Program Suspend/Program Resume Command Sequence
The Program Suspend command allows the system to interrupt a programming operation or
a Write to Buffer programming operation so that data can be read from any non-suspended
sector. When the Program Suspend command is written during a programming process, the
device halts the program operation within 15 µs maximum (5µs typical) and updates the sta-
tus bits. Addresses are not required when writing the Program Suspend command.
After the programming operation is suspended, the system can read array data from any
non-suspended sector. The Program Suspend command may also be issued during a pro-
gramming operation while an erase is suspended. In this case, data may be read from any
addresses not in Erase Suspend or Program Suspend. If a read is needed from the Secured
Silicon Sector area (One-time Program area), then user must use the proper command se-
quences to enter and exit this region. Note that the Secured Silicon Sector autoselect, and
CFI functions are unavailable when program operation is in progress.
The system may also write the autoselect command sequence when the device is in the Pro-
gram Suspend mode. The system can read as many autoselect codes as required. When the
device exits the autoselect mode, the device reverts to the Program Suspend mode, and is
ready for another valid operation. See
information.
After the Program Resume command is written, the device reverts to programming. The sys-
tem can determine the status of the program operation using the DQ7 or DQ6 status bits, just
Note:
page 65
Increment Address
D a t a
See
for program command sequence.
Figure 2. Program Operation
S29GL-N MirrorBit™ Flash Family
Table 12 on page 63
Embedded
in progress
algorithm
S h e e t
Program
No
Autoselect Command Sequence‚ on page 51
Command Sequence
and
Write Program
Last Address?
Programming
from System
Verify Data?
Completed
Data Poll
START
Table 14 on
Yes
Yes
No
for more
55