pi7c8154a Pericom Semiconductor Corporation, pi7c8154a Datasheet - Page 104
![no-image](/images/no-image-200.jpg)
pi7c8154a
Manufacturer Part Number
pi7c8154a
Description
2-port Pci-to-pci Bridge
Manufacturer
Pericom Semiconductor Corporation
Datasheet
1.PI7C8154A.pdf
(112 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
pi7c8154aNAE
Manufacturer:
XILINX
Quantity:
192
16.4
16.5
16.6
BYPASS REGISTER
The required bypass register, a one-bit shift register, provides the shortest path between TDI and
TDO when a bypass instruction is in effect. This allows rapid movement of test data to and from
other components on the board. This path can be selected when no test operation is being
performed on the PI7C8154A.
BOUNDARY SCAN REGISTER
The boundary-scan register contains a cell for each pin as well as control cells for I/O and the high-
impedance pin. Table 16-2shows the bit order of the PI7C8154A boundary-scan register. All table
cells that contain “Control” select the direction of bi-directional pins or high-impedance output
pins. When a “1” is loaded into the control cell, the associated pin(s) are high-impedance or
selected as output.
The boundary-scan register is a required set of serial-shiftable register cells, configured in
master/slave stages and connected between each of the PI7C8154A’s pins and on-chip system
logic. The VDD, GND, and JTAG pins are NOT in the boundary-scan chain.
The boundary-scan register cells are dedicated logic and do not have any system function. Data
may be loaded into the boundary-scan register master cells from the device input pins and output
pin-drivers in parallel by the mandatory SAMPLE and EXTEST instructions. Parallel loading takes
place on the rising edge of TCK.
Data may be scanned into the boundary-scan register serially via the TDI serial input pin, clocked
by the rising edge of TCK. When the required data has been loaded into the master-cell stages, it
can be driven into the system logic at input pins or onto the output pins on the falling edge of TCK
state. Data may also be shifted out of the boundary-scan register by means of the TDO serial output
pin at the falling edge of TCK.
TAP CONTROLLER
The TAP (Test Access Port) controller is a 4-state synchronous finite state machine that controls
the sequence of test logic operations. The TAP can be controlled via a bus master. The bus master
can be either automatic test equipment or a component (i.e., PLD) that interfaces to the TAP. The
TAP controller changes state only in response to a rising edge of TCK. The value of the test mode
state (TMS) input signal at a rising edge of TCK controls the sequence of state changes. The TAP
controller is initialized after power-up by applying a low to the TRST# pin. In addition, the TAP
controller can be initialized by applying a high signal level on the TMS input for a minimum of
five TCK periods.
For greater detail on the behavior of the TAP controller, test logic in each controller state and the
state machine and public instructions, refer to the IEEE 1149.1 Standard Test Access Port and
Boundary-Scan Architecture document (available from the IEEE).
Page 104 of 112
ASYNCHRONOUS 2-PORT
JULY 2004 REVISION 1.00
PCI-to-PCI BRIDGE
Advance Information
PI7C8154A