pcf8534a NXP Semiconductors, pcf8534a Datasheet - Page 20
![no-image](/images/manufacturer_photos/0/4/487/nxp_semiconductors_sml.jpg)
pcf8534a
Manufacturer Part Number
pcf8534a
Description
Universal Lcd Driver For Low Multiplex Rates
Manufacturer
NXP Semiconductors
Datasheet
1.PCF8534A.pdf
(44 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
pcf8534aH/1
Manufacturer:
NXP/恩智浦
Quantity:
20 000
Company:
Part Number:
pcf8534aH/1,518
Manufacturer:
NXP Semiconductors
Quantity:
10 000
Part Number:
pcf8534aH/1,518
Manufacturer:
NXP/恩智浦
Quantity:
20 000
Part Number:
pcf8534aHL/1
Manufacturer:
NXP/恩智浦
Quantity:
20 000
Company:
Part Number:
pcf8534aHL/1,518
Manufacturer:
NXP Semiconductors
Quantity:
10 000
Company:
Part Number:
pcf8534aU/DA/1
Manufacturer:
PHILIPS
Quantity:
201
NXP Semiconductors
PCF8534A_3
Product data sheet
8.1.4 PCF8534A I
8.1.5 Input filters
Acknowledgement on the I
The PCF8534A acts as an I
transmit data to an I
the acknowledge signals of the selected devices. Device selection depends on the
I
In single device application, the hardware subaddress inputs A0, A1 and A2 are normally
tied to V
A0, A1 and A2 are tied to V
devices with a common I
To enhance noise immunity in electrically adverse environments, RC low-pass filters are
provided on the SDA and SCL lines.
2
Fig 15. Acknowledgement of the I
•
•
•
•
C-bus slave address, the transferred command data and the hardware subaddress.
A slave receiver which is addressed must generate an acknowledge after the
reception of each byte.
A master receiver must generate an acknowledge after the reception of each byte that
has been clocked out of the slave transmitter.
The device that acknowledges must pull-down the SDA line during the acknowledge
clock pulse, so that the SDA line is stable LOW during the HIGH period of the
acknowledge related clock pulse (set-up and hold times must be taken into
consideration).
A master receiver must signal an end-of-data to the transmitter by not generating an
acknowledge on the last byte that has been clocked out of the slave. In this event, the
master receiver must leave the data line HIGH during the 9th pulse to not
acknowledge. The master will now generate a STOP condition.
by transmitter
SS
data output
by receiver
data output
SCL from
which defines the hardware subaddress 0. In multiple device applications
master
2
C-bus controller
2
condition
C-bus master receiver. The only data output from the PCF8534A are
START
Rev. 03 — 10 November 2008
S
2
C-bus slave address have the same hardware subaddress.
2
SS
C-bus is illustrated in
2
C-bus slave receiver. It does not initiate I
or V
DD
2
1
C-bus
using a binary coding scheme so that no two
Universal LCD driver for low multiplex rates
2
Figure
15.
not acknowledge
acknowledge
8
PCF8534A
acknowledgement
2
clock pulse for
C-bus transfers or
© NXP B.V. 2008. All rights reserved.
9
mbc602
20 of 44