isp1504a NXP Semiconductors, isp1504a Datasheet - Page 78

• Manufacturer Part Number: isp1504a
• Description: Ulpi Hi-speed Universal Serial Bus On-the-go Transceiver
• Manufacturer: NXP Semiconductors

NXP Semiconductors
21. Revision history
Table 63.
ISP1504A_ISP1504C_3
Product data sheet
Document ID
ISP1504A_ISP1504C_3
Modifications:
ISP1504A_ISP1504C_2
Modifications:
ISP1504A_ISP1504C_1
Revision history
Release date
20080407
20070925
20061019
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Changed On-The-Go Supplement to the USB 2.0 Specification from Rev. 1.2 to Rev. 1.3.
Section 2
Section 8.2 “USB and OTG state
Section 9.10.1 “Full-speed or low-speed host-initiated suspend and
second list item.
Section 9.10.2 “High-speed suspend and
Table 43 “Power Control register (address R = 3Dh to 3Fh, W = 3Dh, S = 3Eh, C = 3Fh) bit
description”: updated description for bits 3 and 2.
Table 56 “Dynamic characteristics: reset and
Removed reference to input clock mode from the following sections:
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
Globally changed mini-USB, mini-A and mini-B connectors to micro-USB, micro-A and
micro-B connectors, respectively.
Table 2 “Pin description”: updated the pin 7 description.
Section 9.4.2 “Fault detection”: updated.
Section “Standard USB host controllers”: updated the first list item.
Section 10.2 “Extended register set”: updated the second paragraph.
Table 44 “Limiting values”: added V
Table 56 “Dynamic characteristics: reset and clock”: added
Table 57 “Dynamic characteristics: digital I/O pins”: updated values.
Section 16 “Application information”: updated.
Section 2 “Features”
Section 5 “Block diagram”
Table 2 “Pin description”
Section 7.5 “Crystal oscillator and PLL”
Section 7.9.2 “V
Section 7.9.13 “XTAL1 and XTAL2”
Section 7.9.18 “CLOCK”
Table 4 “ULPI signal description”
Section 9.3 “Power-up, reset and bus idle sequence”
Table 44 “Limiting values”
Table 45 “Recommended operating conditions”
Table 47 “Static characteristics: digital pins”
Table 56 “Dynamic characteristics: reset and clock”
Table 57 “Dynamic characteristics: digital I/O pins”
Section 16 “Application information”
“Features”: updated.
Data sheet status
Product data sheet
Product data sheet
Product data sheet
Rev. 03 — 7 April 2008
CC(I/O)
”
transitions”: updated the first sentence.
I
on the DP and DM pins and added Table note 1.
resume”: updated the second list item.
ISP1504A; ISP1504C
Change notice
-
-
-
clock”: removed condition from f
ULPI HS USB OTG transceiver
i(XTAL1)
Supersedes
ISP1504A_ISP1504C_2
ISP1504A_ISP1504C_1
-
and Table note 1.
resume”: updated the
© NXP B.V. 2008. All rights reserved.
o(CLOCK)
77 of 82
.