adm6996f Infineon Technologies Corporation, adm6996f Datasheet - Page 17

• Manufacturer Part Number: adm6996f
• Description: 6 Port 10/100 Mb/s Single Chip Ethernet Switch Controller
• Manufacturer: Infineon Technologies Corporation

ADM6996F
Infineon-ADMtek Co Ltd
2.2.5 EEPROM/Management Interface
2.2.6 Power/Ground, 48 pins
2.2.7 Miscellaneous
Pin Name
EDO
EECS
EECK
Setting
XOVEN
EDI
Setting
LEDMODE
Pin Name
GNDA
VCCA2
VCCAD
GNDBIAS
VCCBIAS
GNDPLL
VCCPLL
GNDIK
VCCIK
GNDO
VCC3O
Pin Name
CKO25M
4,5,12, 13, 20, 27,
45, 64, 76, 83, 93,
46, 65, 75, 82, 94,
50, 69, 70, 87, 99,
1, 9, 17, 24, 38
49, 71, 88, 109
8, 16, 23, 31
28, 34, 35
Pin#
Pin#
Pin#
126
128
123
122
118
116
108
84
80
81
79
85
4mA,PD
TTL,PU
Type
Type
Type
4mA
4mA
I/O,
I/O,
PD
PD
O,
O,
I,
I
I
I
I
I
I
I
I
I
I
I
1.8V, Power Used by TX Line Driver.
3.3V, Power Used by AD Block.
1.8V, Power used by PLL
3.3V, Power Used by Digital Pad.
Descriptions
EEPROM Data Output. Serial data input from EEPROM.
This pin is internally pull-up.
EEPROM Chip Select. This pin is active high chip enable
for EEPROM. When RESETL is low, it will be Tri-state.
Internally Pull-down
Serial Clock. This pin is clock source for EEPROM. When
RESETL is low, it will be tri-state.
Setting
XOVEN: This pin is internal pull-down. On power-on-reset,
latched as P4~0 Auto MDIX enable or not.
“0” to disable MDIX ( defaulted ), “1” to enable MDIX.
Suggest externally pull up to enable MDIX for all ports.
EEPROM Serial Data Input. This pin is output for serial
data transfer. When RESETL is low, it will be tri-state.
Setting
LEDMODE: This pin is internal pull-down. On power-on-
reset, latched as Dual Color mode or not.
“0” to set Single color mode for LED.
“1” to set Dual Color mode for LED.
Descriptions
Ground Used by AD Block.
Ground Used by Bias Block
3.3V, Power Used by Bias Block.
Ground used by PLL
Ground Used by Digital Core
1.8V, Power Used by Digital Core
Ground Used by Digital Pad
Descriptions
25M Clock Output.
Interface Description
2-6