at85c51snd3 ATMEL Corporation, at85c51snd3 Datasheet - Page 112

• Manufacturer Part Number: at85c51snd3
• Description: At85c51snd3 Single-chip Digital Audio Decoder - Encoder With Usb 2.0 Interface
• Manufacturer: ATMEL Corporation

Isochronous Mode
Underflow
CRC Error
Overflow
112
AT85C51SND3B
Table 111. Abort flow
For Isochronous IN endpoints, it is possible to automatically switch the banks on each
start of frame (SOF). This is done by setting ISOSW. The CPU has to fill the bank of the
endpoint; the bank switching will be automatic as soon as a SOF is seen by the
hardware.
A clear of FIFOCON does not have any effects in this mode.
In the case that a SOF is missing (noise on USB pad, …), the controller will automati-
cally build internally a “pseudo” start of frame and the bank switching is made. The SOFI
interrupt is triggered and the frame number FNUM10:0 is increased.
An underflow can occur during IN stage if the host attempts to read a bank which is
empty. In this situation, the UNDERFI interrupt is triggered.
An underflow can also occur during OUT stage if the host send a packet while the banks
are already full. Typically, he CPU is not fast enough. The packet is lost.
It is not possible to have underflow error during OUT stage, in the CPU side, since the
CPU should read only if the bank is ready to give data (RXOUTI=1 or RWAL=1)
A CRC error can occur during OUT stage if the USB controller detects a bad received
packet. In this situation, the STALLI interrupt is triggered. This does not prevent the
RXOUTI interrupt from being triggered.
In Control, Isochronous, Bulk or Interrupt Endpoint, an overflow can occur during OUT
stage, if the host attempts to write in a bank that is too small for the packet. In this situa-
tion, the OVERFI interrupt is triggered (if enabled). The packet is acknowledged and the
RXOUTI interrupt is also triggered (if enabled). The bank is filled with the first bytes of
the packet.
It is not possible to have overflow error during IN stage, in the CPU side, since the CPU
should write only if the bank is ready to access data (TXINI=1 or RWAL=1).
Abort done
NBUSYBK
Endpoint
UEIENX.
Endpoint
TXINE
Abort
Clear
reset
=0
Yes
No
Yes
KILLBK=1
KILLBK=1
No
Disable the TXINI interrupt.
Abort is based on the fact
that no banks are busy,
meaning that nothing has to
be sent.
Kill the last written
bank.
Wait for the end of the
procedure.
7632D–MP3–01/07