sc16is762ipw NXP Semiconductors, sc16is762ipw Datasheet - Page 37
![no-image](/images/manufacturer_photos/0/4/487/nxp_semiconductors_sml.jpg)
sc16is762ipw
Manufacturer Part Number
sc16is762ipw
Description
Dual Uart With I2c-bus/spi Interface, 64 Bytes Of Transmit And Receive Fifos, Irda Sir Built-in Support
Manufacturer
NXP Semiconductors
Datasheet
1.SC16IS762IPW.pdf
(59 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
SC16IS762IPW
Manufacturer:
NXP
Quantity:
8 024
Company:
Part Number:
sc16is762ipw128
Manufacturer:
NXP Semiconductors
Quantity:
1 925
NXP Semiconductors
SC16IS752_SC16IS762_6
Product data sheet
Fig 16. A complete data transfer
SDA
SCL
condition
START
10.2 Addressing and transfer formats
S
Each device on the bus has its own unique address. Before any data is transmitted on the
bus, the master transmits on the bus the address of the slave to be accessed for this
transaction. A well-behaved slave with a matching address, if it exists on the network,
should of course acknowledge the master's addressing. The addressing is done by the
first byte transmitted by the master after the START condition.
An address on the network is seven bits long, appearing as the most significant bits of the
address byte. The last bit is a direction (R/W) bit. A zero indicates that the master is
transmitting (‘write’) and a one indicates that the master requests data (‘read’). A complete
data transfer, comprised of an address byte indicating a ‘write’ and two data bytes is
shown in
When an address is sent, each device in the system compares the first seven bits after the
START with its own address. If there is a match, the device will consider itself addressed
by the master, and will send an acknowledge. The device could also determine if in this
transaction it is assigned the role of a slave receiver or slave transmitter, depending on the
R/W bit.
Each node of the I
microcontroller is of course fully programmable, while peripheral devices usually have
fixed and programmable address portions.
When the master is communicating with one device only, data transfers follow the format
of
transfer and issuing a STOP condition, if a master would like to address some other
device on the network, it could start another transaction by issuing a new START.
Another way for a master to communicate with several different devices would be by using
a ‘Repeated START’. After the last byte of the transaction was transferred, including its
acknowledge (or negative acknowledge), the master issues another START, followed by
address byte and data without effecting a STOP. The master may communicate with a
number of different devices, combining ‘reads’ and ‘writes’. After the last transfer takes
place, the master issues a STOP and releases the bus. Possible data formats are
demonstrated in
slave and a change of direction, without releasing the bus. We shall see later on that the
change of direction feature can come in handy even when dealing with a single device.
address
Figure
0 to 6
Figure
16, where the R/W bit could indicate either direction. After completing the
R/W
7
16.
Figure
ACK
2
8
C-bus network has a unique seven-bit address. The address of a
Rev. 06 — 19 December 2006
Dual UART with I
17. Note that the repeated START allows for both change of a
0 to 6
data
7
2
SC16IS752/SC16IS762
ACK
C-bus/SPI interface, 64-byte FIFOs, IrDA SIR
8
0 to 6
data
7
ACK
8
© NXP B.V. 2006. All rights reserved.
condition
STOP
P
002aab046
37 of 59