a54sx16p Actel Corporation, a54sx16p Datasheet - Page 11

• Manufacturer Part Number: a54sx16p
• Description: Sx Family Fpgas
• Manufacturer: Actel Corporation

Figure 1-8 •
Programming
Device programming is supported through Silicon
Sculptor series of programmers. In particular, Silicon
Sculptor II are compact, robust, single-site and multi-site
device programmer for the PC.
With standalone software, Silicon Sculptor II allows
concurrent programming of multiple units from the
same PC, ensuring the fastest programming times
possible. Each fuse is subsequently verified by Silicon
Sculptor II to insure correct programming. In addition,
integrity
programmed. Silicon Sculptor II also provides extensive
hardware self-testing capability.
3.3 V / 5 V Operating Conditions
Table 1-3 •
Symbol
V
V
V
V
V
V
I
T
Notes:
1. Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. Exposure to absolute
2. V
3. Device inputs are normally high impedance and draw extremely low current. However, when input voltage is greater than V
IO
STG
CCR
CCA
CCI
CCI
I
O
maximum rated conditions for extended periods may affect device reliability. Device should not be operated outside the
Recommended Operating Conditions.
operation.
0.5 V or less than GND – 0.5 V, the internal protection diodes will forward-bias and can draw excessive current.
2
2
2
2
CCR
in the A54SX16P must be greater than or equal to V
tests
Probe Setup
Absolute Maximum Ratings
DC Supply Voltage
DC Supply Voltage
DC Supply Voltage (A54SX08, A54SX16, A54SX32)
DC Supply Voltage (A54SX16P)
Input Voltage
Output Voltage
I/O Source Sink Current
Storage Temperature
ensure
Serial Connection
that
no
3
3
extra
Parameter
1
Explorer II
Silicon
fuses
16 Channels
are
CCI
v3.2
during power-up and power-down sequences and during normal
The procedure for programming an SX device using
Silicon Sculptor II are as follows:
When the design is ready to go to production, Actel
offers
through
programming from the factory.
For more details on programming SX devices, refer to the
Programming Antifuse Devices
Silicon Sculptor II User's
1. Load the .AFM file
2. Select the device to be programmed
3. Begin programming
TMS
TDO
TDI
TCK
PRA
PRB
device
distribution
volume-programming
–0.3 to + 6.0
–0.3 to + 4.0
–0.3 to + 4.0
–0.3 to + 6.0
–0.5 to + 5.5
–0.5 to + 3.6
–30 to + 5.0
–65 to +150
Limits
Guide.
SX FPGA
partners
application note and the
or
SX Family FPGAs
services
via
Units
mA
°C
V
V
V
V
V
V
in-house
either
CC
1-7
+